COMPASS HEALTH B650 User manual

Seat/
Asiento x 1
Leg Extensions/
Extensiones de Pierna x 4
Washers/Arandelas x 5
Screws/Tornillos x 5
U Bars/
Barras U x 2
Labeled “1”
and “2”
B650
WEIGHT CAPACITY: 350 lbs
CAPACIDAD DE PESO: 350 libras
1
1
x4
1
1
2
2
Back
Front
Place seat face-down on a table or counter with the
FRONT edge closest to you (BACK edge has the
shower sprayer notches, FRONT edge does not). Place U
bar labeled “1” in the groove in the seat which extends from
BACK LEFT corner of seat to RIGHT FRONT corner of seat,
as shown in Figure 1., above. Place the U bar labeled “2” in
the other groove, on top of U bar “1.” NOTE: when placed
correctly, the 2 U bars will align at the center as shown in
Figure 2., above.
WARNING: Failure to assemble this bath seat correctly can
result in falls/injuries.
Coloque el asiento boca abajo sobre una mesa o mostrador
con el borde del asiento cerca del borde de la mesa. Coloque
la barra en U etiquetada “1” en la ranura del asiento, de
modo que el “1” en la barra esté al lado del “1” en el asiento.
Coloque la barra en U etiquetada “2” en el asiento para que
el “2” en la barra esté al lado del “2” en el asiento.
Place screws with washers into the holes through
both U bars and into the screw holes in the seat.
Contour of the washers should match the curve of the bar.
Tighten the screws. Periodically check to assure that all
screws remain tight.
%QNQSWGNQUVQTPKNNQUEQPCTCPFGNCUGPNQUQTKƂEKQUCVTCXÅU
FGCODCUDCTTCUGP7[FGPVTQFGNQUQTKƂEKQURCTCVQTPKNNQU
en el asiento. El contorno de las arandelas debe coincidir
con la curva de la barra. Apretar los tornillos. Controle
periódicamente para asegurarse de que todos los tornillos
estén apretados.
Figure 2.
Proper alignment of U bars
Figure 1.
Correct placement of U Bars
Figure 3.
Securing U bars to seat
12
Made in China
42-B65000_01 ©2018
Manufactured for: Compass Health Brands Corp.
Middleburg Heights, OH 44130
www.compasshealthbrands.com • 800.376.7263 1
Assembly Instructions/
Instrucciones de montaje
Bath and Shower Seat/
Asiento de baño y ducha
Back
Front
2
1
2
1

Check for stability. Assure all pins are completely
through the holes and legs are all the same height.
Place Bath and Shower Bench in shower or bath on a level
surface. Periodically check to assure that all screws remain
tight. Place Bath and Shower Bench in shower or bath, on a
level surface.
8GTKƂECNCGUVCDKNKFCF#UGIÖTGUGFGSWGVQFQUNQURCUCFQTGU
estén completamente a través de los agujeros y que las patas
tengan la misma altura. Coloque el banco de seguridad para
baño y ducha en la ducha o el baño. Controle periódicamente
para asegurarse de que todos los tornillos estén apretados.
4
Slip leg extensions on, push copper pin and slide on,
line up pin and hole so pin pops through leg extension
hole completely. Repeat for all 4 legs. Adjust height so all legs
are the same height.
Deslice las extensiones de pierna, empuje el pasador de
EQDTG[FGUNÉEGNQCNKPGGGNRCUCFQT[GNQTKƂEKQRCTCSWGGN
RCUCFQTUCNICRQTEQORNGVQFGNQTKƂEKQFGGZVGPUKÏPFGNC
pierna. Repita para las 4 patas. Ajuste la altura para que todas
las piernas sean iguales.
Manufactured for: Compass Health Brands Corp.
Middleburg Heights, OH 44130
www.compasshealthbrands.com • 800.376.7263 2Made in China
42-B65000_01 ©2018
Assembly Instructions/
Instrucciones de montaje
Bath and Shower Seat/
Asiento de baño y ducha
3