together at the same time, so that they can operate simultaneously.
Press the “on/off” button of the socket (for approximately 10
seconds) until the green LED light starts ashing. If you also wish
to use the receiver unit of the thermostat, then start the tuning
process on that receiver unit too, as described in its manual, so
that its green LED light (or red LED light in case of the receiver of
the Q8RF thermostat) starts ashing. After this, tune the devices
together according to the manual of the thermostat. If the LED lights
stop ashing, then the devices are tuned together.
4. TRANSMISSION DISTANCE INSPECTION
With the help of the “TEST” button you can check whether the
thermostat and the socket are within the transmission distance of
the radio-frequency connection. To perform the test, press the “TEST”
4
