Concept2 D1 User manual

2
MANUAL &
TECHNIQUE DVD
ASSEMBLY
unpacking
your
concept2
indoor
rower
You should find the following parts for your
Indoor Rower in this shipping box. If any
parts are missing, please call us toll-free at
1.800.245.5676.
contents of parts bag (pn1752)
PN 1144
PN 1792
PN 1205
PN 1225
PN 1248
PN 1936
PN 1946
PN 1173
PN 1172
PN 1935
PN 296
PN 1752

3
ASSEMBLY
assembling
the
front leg
tool needed:
Allen Wrench (provided)
parts needed:
4 washers
4 screws
23.5”
(60cm)
long
leg
19”
(49cm)
short
leg
Note that the longer leg (I) attaches to same side as the wheels.
3/4”
or 2cm

4
parts needed:
4 washers
4 screws
tool needed:
Allen Wrench (provided)
➀
➂➃
➁
This is an illustration of the bottom view
of the front end/flywheel housing.
Insert socket screws in this order.
attaching
the
front leg
ASSEMBLY
Attach the front leg as shown
in the illustration.
Note the leg lengths.
19”
(49cm)
23.5”
(60cm)
3/4”
or 2cm
1
3
2
4

5
ASSEMBLY
assembling
& installing
the
frame lock
parts needed:
2 washers
2 screws
tool needed:
Allen Wrench (provided)
1. Insert axle through axle tube on
framelock.
2. Place framelock between
footplates on Indoor Rower. The
two footplates may need to be
pulled apart slightly for the axle
tube to fit. Be sure to line up
axle tube to orient framelock as
shown.
3. Insert 3/4” screw and washer
into each end of framelock axle
tube, through holes in footplates.
Tighten with allen wrench.
3/4”
or 2cm

6
• Alwayshavetheframelockinthelockedposition
when the flywheel and monorail sections are
connected. Failure to do so may result in injury if
the unit is lifted or moved.
attaching
the
monorail
Place the flywheel and monorail
sections of the Indoor Rower
end to end.
1. Using one of the footstraps as
a handle, lift the footboard end
of the flywheel section until it
rolls on the caster wheels. Lift
the end of the monorail to the
same level.
2.Bring the flywheel and monorail
sections together between the
footplates. The top hanger should
be over the top bolt tube and the
bottom hanger should hook over
the bottom bolt tube.
3.Lower both pieces until they
connect securely and push down
into place.
4.Rotate the framelock
around and push it into
the locked position.
• Toavoidpossibleinjury,usecautionwhile
attaching the monorail section to the flywheel
section and while operating the framelock.
caution
USING THE
INDOOR ROWER
locked

7
detaching
the
monorail
1. Release the framelock from the locked position by pulling up on the rope,
allowing the framelock to rotate into the unlocked position.
2. Using the footstrap, lift the
monorail slightly with one
hand to disengage.
3. Remove monorail with the
other hand.
The two parts may
be placed upright as
shown here for more
compact storage.
Care should be taken
when standing the
flywheel section up
as the balance may
shift suddenly.
storage
caution
USING THE
INDOOR ROWER
unlocked