Step 1: Install the foam pads [4 for
36” step, 12 for 74” step ] on the flat
spots lo ated on the bottom edge of
sidewall.
Step 2: Using a rubber mallet install
one of the 3” supports into the slot
lo ated on the bottom of sidewall.
[36” step will have 2 sidewall, 74” will
have 4 sidewall]. Install one plug into
ea h sidewall.
Step 3: Turn the step assembly over
and finish installing the 3” supports,
[6 for 3-step, 8 for 4-step] into the front
and ba k slots of ea h step lo ation .
Step 4: Using a rubber mallet, install
the four handrail posts into the middle
slots of the top two step lo ations on
the left sidewall, and the top two step
lo ations of the right sidewall. Handrail
posts must be seated into the slots.
Step 7: Se ure handrails using 1- # 10 x
1¼” s rew into ea h post at pre-marked
lo ations.
Step 8: Install the steps [finished edge
out] by pla ing over the male lugs on the
step sidewall and hitting downward with a
rubber mallet.
Step 5: Install towel ra k/ up holder
over the handrail posts with the towel ra k
to the outside of step, tap in pla e using
the rubber mallet. Towel ra k/ up holder
may be positioned anywhere on the post.
Step 6: Tap the handrails into the
handrail posts.
Confer - Signature Spa Steps
ASSEMBLY AND INSTRUCTION MANUAL
NOTE: STE ARTS ARE DESIGNED FOR A TIGHT FIT, USING LIQUID SOA
DETERGENT WILL MAKE ASSEMBLY EASIER.
MADE IN THE U.S.A. BY:
Signature spa step 3-00-SSS-1 12/13
Printed in U.S.A.
97 W tmer Road
North Tonawanda, NY USA 14120-2421
800-635-3213
Fax: 716-694-3102
www.conferladders.com
ema l: ladders@conferplast cs.com
Confer_SigSpa-US-12-13r3:layo t 12/26/13 4:12 PM Page 2
