Conquer CQL1511-B User manual

CQL1511-B Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power:
zPlease charge your Bluetooth speaker fully before its first use.
To charge the battery:
zUsing a Micro USB cable (included), insert the USB power cable into the micro USB port located
on the back of the speaker. Connect the other end of the USB cord into a powered USB source
such as a computer, laptop or USB AC adapter.
zWhen your Bluetooth speaker is charging, the indicator light will turn red.
zOnce your Bluetooth speaker is fully charged, the red light will turn off.
Playing Music Via Bluetooth
zTurn your Bluetooth speaker on by sliding the power switch located on the back of the speaker to
‘ON’ position.
zThe blue indicator light will flash quickly. This indicates that the speaker is in pairing mode and is
searching for your Bluetooth device.
zMake sure the Bluetooth function on your device is turned on.
zSearch the speaker named,”xxxx”.
zOnce you have selected the speaker, your device will pair without a password. (If your device
prompts for a password, enter the password”0000”.
zOnce your speaker is paired, the blue indicator light will begin to flash slower.
zStart playing music on your device. Make sure that you keep your device within a 33 feet range of
your Bluetooth speaker.
zAdjust the volume of your device to a comfortable level.
zTurn off the unit when not in use.
Warning:
This is not a toy. Please keep away from children.
Please keep away from water / heat.
Low power may cause poor connection or may cause the Bluetooth function to not work
FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment .
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.