Converters.TV 173 User manual

Video (PAL or NTSC) to RGB
Converter with 12v Relay Switch for
Rever e Camera ID# 173
Operation Manual

Introduction
The Video (PAL or NTSC) to RGB Converter with 12v Relay Switch for
Rever e Camera allow video ignal from NTSC/PAL/SECAM to be
converted into RGB/Sync or RGB B(Sync On Green) to allow video to be
viewed on mo t in-car LCD creen .
It al o include 12volt trigger for rever e camera input. Thi enable you to
add rever e camera to your car - when the car i placed into rever e, the
12volt relay trigger the video ource to come on from the camera to
override your navigation creen.
Plea e note that thi i one way tyle conver ion;
NTSC Video to NTSC RGB OR
PAL Video to PAL RGB
Feature
• Digital decoding and encoding en ure be t conver ion quality.
• Convert NTSC/PAL/SECAM compo ite video to RGB/Sync or
RGB B(Sync on
Green).
• Input Sy tem auto detecting.
• RGB input loop through.
• Sync Polarity witchable between po itive and negative.
• Output brightne adju table..
Operating Function
and Control
Front Panel

1. - And + button /re et button- The – and + button are u ed to decrea e
and increa e the brightne level re pectively. Simultaneou ly pre ing the –
and + button return brightne to it factory default value.
2. RGB /RG B witch- Thi button allow the u er to elect between RG B
(Sync on Green) or RGB .
3. 9 Pin D Female connector:-
Pin No. Wire Colour Function
Pin 1 Grey GND
Pin 2 Brown Sync of ource 1
Pin 3 Red Red out
Pin 4 Yellow Red in from ource1
Pin 5 Green Green in from ource1
Pin 6 Blue Green out
Pin 7 Purple Blue out
Pin 8 Orange Blue in from ource 1
Pin 9 Black Sync out
Source 1: Loop through RGB/S input
Source 2: Video Input
4. Toggle witch- Toggle between convert and RGB bypa .
Rear Panel
1. DC power upply input- Thi i the power upply input port.
2. Video input- Thi i the Compo ite Video input port.
3. Control wire - When the control wire i connected to 12 Volt, it force
the unit to go into convert mode. When the control wire ha no voltage
apply to it, the toggle witch will dictate the convert/bypa mode.

Connection &
In tallation
- Connect the RGB out port to your RGB device u ing a 9 Pin D female
connector.
- Set the witch to either RGB or RG B.
- U e the - and + to adju t the level of brightne to the de ired level.
- Connect the Video input port to you video device u ing a Compo ite
Video RCA jack.
- Connect the control wire. If the control wire i connected to 12V the unit
will be automatically forced to go into convert mode. If there i no voltage
applied to the
control wi e, then the toggle witch will decide the convert mode.
- When all the connection are complete en ure that the power upply i
connected to the power ocket.
Specification
Input Video input- 1Vp-p 75 ohm RCA Jack
RGB input: Pa through
Output RGB: 0.7 Vp-p 75 ohm 9-pin D female connector.
Sync: 3 Vp-p po itive or negative polarity
Power Supply DC 12V center po itive
Dimen ion 94mm (D) x 77mm (W) x 30mm (H)
Acce ory One et of D-Sub 9 Pin RGB bare wire and
one et of 2-wire power.
Weight 0.4 Kg