Cooledge TILE TNW EXTERIOR R3 User manual

EXT-0080-R01-04052022 (LTR) 1/5
COOLEDGE TILE TNW EXTERIOR R3 - QUICKSTART GUIDE
Caution: Observe precautions for handling electrostatically sensitive devices.
1.6”
8.6”
3.4”
Cut TILE
Cutout TILE
Jumper Cable
Starter Cable
Must be mounted in an IP rated
enclosure if installed outdoors
Waterproof
Cable Splices
Cable Clamp
T-Cable
T-Cable
End Cap
Power Supply Control Module
AC
TILE
Cooledge Lighting Inc.
110–13551 Commerce Parkway
Richmond, BC V6V 2L1 Canada
Cooledge Lighting reserves the right to change
materials or modify the design of its product
without notification as part of the company’s
continuing product improvement program.
O [phone]
F [phone]
T [phone]
W cooledgelighting.com
5 Year Limited Warranty:
Parts and workmanship
5
5
Y
E
A
R
S
Y
S
T
E
M
W
A
R
R
A
N
T
Y
5
Y
E
A
R
S
Y
S
T
E
M
W
A
R
R
A
N
T
Y
For detailed instructions, please refer to:
- EXT-0102-R00 TILE TNW Exterior R3 Installation Guide

EXT-0080-R01-04052022 (LTR) 2/5
Staple inside circles
(Max recommended
staple size = 1/2” or 12mm)
Install with screws
and plastic washers
(M4 or #8 screw)
NOTE: Mounting surface must be non-conductive (eg.
drywall, plywood, etc)
Snap together to
connect light sheets
EXTERIOR TILEs CANNOT BE CUT.
Cutting of the TILEs will compromise the protective coating.
Each TILE is cut according to the submittal drawing in the
factory. Refer to the identification label on the back of each
TILE and job submittal for the installation location.
Electric staple gun
recommended.
or
11.8”
300 mm
1
2
E
DETAIL E
SCALE 2 : 1
INSTALL EXTERIOR TILE
PRE-CUT EXTERIOR TILES AND CUTOUTS TILES

EXT-0080-R01-04052022 (LTR) 3/5
3
4
5
INSTALL CUT-OUT TILE(S)
INSTALL T-CABLE AND CUT TO SIZE
INSTALL CUT-OUT TILE IN CORNER
Power
Supply Control
Module
AC
Install with screws and plastic washers.
Do not use staples on the Cut-out TILE.
Install with screws and plastic washers.
Do not use staples on the Cut-out TILE.
Power
Supply Control Module
Optional for TILE Exterior
Must be mounted in an IP rated
enclosure if installed outdoors

EXT-0080-R01-04052022 (LTR) 4/5
1” (2.5CM) MINIMUM
BEND RADIUS
DO NOT BEND SHEETS SHARPLY AROUND CORNERS
CONNECTOR TAB INSULATION SPLICE CONNECTOR INSTALLATION
Cover any free hanging connector tabs
with insulating tape.

EXT-0080-R01-04052022 (LTR) 5/5
STARTER KIT CONTENTS
CUT-OUT KIT CONTENTS
Cut Tile Reuse Jumper Cable (4) Splice Connector (2)
T-Cable End Cap (4)
Quick
Start
Guide
16 AWG (1.3mm2) Cable,
10ft (3m) Length
Cut-out TILE
Cut-out TILEs will be pre-cut and
may not match the image shown.
Jumper Cable (2)
Insulating Patches (2) Cable Clamp (2)
Splice Connector (6)