Cooper Lighting LF User manual

COOPER LIGHTING
LF FLEXIBLE TRACK
Structural
Extruded aluminum I-beam 0.060” nomi-
nal wall thickness. Flexible Track is 1-
1/2” high by 7/16” wide.
120V and 12V Conductors
Nickel-plated solid copper bus bars
(cross section equivalent to #10AWG
wire) encased in extruded CPVC insula-
tors.
Insulating Liner
Extruded polyvinyl insulators.
Grounding
Grounding is accomplished through a
grounding channel in the track. The
track maintains continuity to the track
connectors, lampholders and building”s
grounding system through this channel.
Polarity
Track is asymmetric in nature and
accepts connectors and lampholders in
one direction only to maintain polarity.
Details
• Track ships with two dead ends. Track
minimum bend radius is
24 inches.
• Separate power feed is required for
each circuit to be energized
• A track support is required every four
feet. More Supports may be required
depending on the complexity of the
“curved” design layout.
• It is recommended to have a track sup-
port at the apex of every curve.
• A track support is required within six
inches of any non stem supported
connector.
• Track lengths and stems can be cut to
size in field.
Track
LF=Flexible
Track
Finish
AH=Aluminum Haze
LF
Length
4=4”
8=8”
AH
LF601AH 120V Feed with Stem/Canopy
Description: 120V Power feed with canopy and stem mounts on stan-
dard junction box (supplied with feed wires)
Feeds one 120V circuit only.
LF60112AH 12V Feed with Stem/Canopy
Description: 12V Power feed with canopy and stem. mounts on standard
junction box (supplied with feed wires).
Remote 12V transformer required to energize.
Accessory
LF601=Flexible
Track
Voltage
Blank=120V
12=12 Volt
Finish
AH=Aluminum
Haze 4=4”
6=6”
12=12”
18=18”
24=24”
36=36”
48=48”
96=96”
LF601 AH
LF602AH Clam Shell Track Support Stem with Small Canopy (non-conductive)
Description: Rigid stem with clam shell attachment supports the track.
Accessory
LF602=Flexible
Track
Finish
AH=Aluminum
Haze
LF602 AH
LINE
NEUTRAL
Dove Tail
Support Slot
NEUTRAL
LINE
Length
(Ceiling to bottom of track)
6=6”
12=12”
18=18”
24=24”
36=36”
48=48”
96=96”
Length
(Ceiling to bottom of track)
LF612AH Dead End
Description: Finishes end of track. Aluminum Haze finish. (two included with
each track section)
LF
Flexible Track
LF601
Power Feed
LF602
Track Support
7/16”
[11mm]
1-1/2”
[38mm]
HALO®
• ARCHITECTURAL FLEXIBLE TRACK
4” not for use in Canada
346
ARCHITECTURAL TRACK LIGHTING Incandescent