Cooper Lighting Shaper 233 User manual

DIFFUSER SPHERE
SCREWS
CIRCLE STRAP
ASSEMBLY
CANOPY
INSTRUCTIONS:
Unscrew top 4 screws and remove CIRCLE STRAP ASSEMBLY from 1.
CANOPY.
Attach CIRCLE STRAP ASSEMBLY to J-box (by others) using 8-32 2.
screws.
Using U.L. approved wire connectors: connect the luminaire neutral 3.
(white) to the supply neutral, connect the luminaire line wire (black) to the
supply line wire. Fasten green ground wires to ground screw.
Re-attach CANOPY with previously removed screws. 4.
Attach DIFFUSER SPHERE to CANOPY using 4 screws. 5.
CAUTION:
BEFORE INSTALLING AND SERVICING OF LUMINAIRE, EXERCISE
SPECIAL CARE AND HANDLING OF PARTS. PLEASE USE GLOVES
AND PADDED MATERIAL WHILE HANDLING PARTS TO AVOID
SCRATCHING THE FINISH. CLEAN WITH SOFT CLOTHS AND WATER.
11509152
1141 Marina Way South, Richmond, CA 94804 Phone: [phone] Fax:[phone]
INSTALLATION INSTRUCTIONS
NOTICE:
For proper installation, have a qualified
electrician install this product.
Before installation of any luminaire onto an
electrical junction box, be sure to disconnect
power.
This luminaire must be wired and grounded in
accordance with the National Electrical Code,
local codes, and ordinances.
Wire supply connections must be made with U.L.
approved connectors.
Check that luminaire voltage and building
voltage are the same.
6/21/2007 A
MODEL 233