Courtyard Creations RTS889A-WM User manual

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
RTS889A-WM
Do not discard any of the packaging until you have checked that you have all the parts and pack of fittings.
Keep children away during assembly. This item contains small parts which can be swallowed by children.
Children should always be under direct adult supervision while using the product.
Retain the assembly instructions for future reference.
Please quote following FQC NO. when contacting service center.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
PAGE 1 OF 2 COURTYARD CREATIONS INC.
!
!
!
!
STOP DON’T RETURN TO STORE!
FIGURE 1
Attention:
Make sure that each bolt needed for all steps match the corresponding
figure to ensure proper assembly.
Note:
Make sure that the bolts on the seat assembly (#1) are loose before
assembling the chair. See Figure 1.
PARTS LIST
PART
NO. MATERIAL CODE PART Q’TY
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
1
1
1
1
1
4
3
4
6
4
4
4
4
5
4
1
1
1
1
RTS889A-CS01
RTS889A-CS02
RTS889A-CS03
RFS8821-CS04
RTS856D-CS04
17C33A0706001Y4
17C01A0712002Y4
17C03A0814041Y2
17FA05040301-Y4
17FA08060601-Y4
17FA05100701-Y4
17FC08030801-Y2
17D03A040401-Y4
1800337004
1800337002
1800319004
17KAA0101----Y4
17KAA0201----Y4
17KAB1101----Y4
SEAT ASSEMBLY
LEFT ARM
SEAT POST
BASE ASSEMBLY
BOLT M6*16
BOLT M6*35
BOLT M8*40
WASHER d6.5*D13*1.0
WASHER d8.5*D17*1.6
WASHER d6.5*D30*2.0
SPRING WASHER d8.5*D12*2.1
JAM NUT M8*1.25
BOLT CAP
BOLT CAP M6
BOLT CAP M8
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 6MM
NUT WRENCH 10&13MM
RIGHT ARM
1

NOTE: The labels marked “L” and “R” on the arms (#2 and #3) should coincide
with Figure 2 to ensure proper assembly.
L
R
PAGE 2 OF 2
STOP DON’T RETURN TO STORE!
FIGURE 2
16
#6 BOLT M6*16
FIGURE 3
35
#7 BOLT M6*35
FIGURE 4
FIGURE 6
FIGURE 5
STEP 1:
Place the left arm (#2) onto a non-abrasive surface, such as a carpet. At the
front of the chair, fasten the cross brace on the seat assembly (#1) to the arms
(#2 and #3) by using bolts (#6) and washers (#9). Keep the bolts loose.
See Figure 2.
STEP 3:
Turn the chair upside down and place the seat post (#4) to the brace of the
seat assembly (#1). Fasten them together by using bolts (#8), washers (#10),
spring washers (#12), and jam nuts (#13). See Figure 4.
NOTE:
For ease with installation, we recommend that the seat post (#4) be slightly oiled
or waxed before fastening to the base assembly (#5).
STEP 4:
Insert the seat post (#4) into the hole located in the center of the base assembly
(#5). Fasten them together by using bolt (#7) and washer (#11). See Figure 5.
STEP 2:
Fasten both the left arm (#2) and the right arm (#3) to the back assembly (#1)
by using bolts (#7) and washers (#9). See Figure 3.
40
#8 BOLT M8*40
8
8
10
10
12
12
4
4
1
1
13
13
16
16
STEP 5:
Tighten the bolts on the seat assembly (#1). Double check to ensure that all of
the bolts have been tightened completely and then cover them with bolt caps
(#14, #15, and #16). See Figure 6.
CAUTION:
To ensure one’s safety during use of this swivel chair, make sure that all of the
bolts are tightened. This is a chair with the ability to swivel; therefore use by
young children should be adult supervised.
Cleaning and Maintenance
• Wash frame and fabric parts with mild soap and water, rinse thoroughly, and
dry frame completely. Do not use bleach, acid, or other solvents on the frame
or fabric parts.
• We recommend the use of furniture covers when not in use.
• Please inspect and tighten all bolts or fasteners on a regular basis to ensure
proper performance and safety of your swivel chair.
• In order to prolong the life and beauty of your swivel chair, we recommend that
it be stored in a dry and protected area during off season periods.
35
#7 BOLT M6*35
1
3
3
2
7
7
11
15
15
9
1
2
9
96
614
14
4
5
15

Missing A Part?
No Need To Go Back To
TheStore!
The store where you made your purchase
does not stock parts for this item
if you need parts,
whether they are missing or damaged.
Call Toll Free
TEL: [phone]
FAX: [phone]
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
The store where you made your purchase
does not stock parts for this item
if you need parts,
whether they are missing or damaged.
STOP!
Missing A Part?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
Call Toll Free
TEL: [phone]
FAX: [phone]
PLEASE READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
PLEASE SEPARATE AND IDENTIFY ALL PARTS, MAKING SURE THAT YOU
HAVE ALL OF THEPARTSLISTED.
SHOULD YOU NOTLOCATE ALL OF THE ABOVE PARTS, PLEASE INSPECTALL
PACKING MATERIAL FOR ANY SMALL PARTSTHAT MAYHAVEBECOME
SEPARATED IN SHIPMENT.
SHOULD YOU EXPERIENCEANY DIFFICULTY DURING ASSEMBLYOR IF ANY
PARTIS MISSING OR DAMAGED,PLEASE CALL THE HELP LINE 1-877-539-7436
BEFORERETURNING THE ITEM TO THE STORE.
PLEASE PROVIDE THEFOLLOWING INFORMATION:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS LIST
SHOWN ON ASSEMBLY INSTRUCTIONS.
MOST PROBLEMS CAN BERESOLVED WITHOUT RETURNING THIS PRODUCT
TO THERETAILER.