Cradlepoint MBR95 User manual

Contents:
Instructions:
1. Install the USB Modem into the USB port on the back of the router.
2. Connect the AC power supply to the power port on the Cradlepoint router.
Plug the other end into a standard 110V AC wall outlet or power strip. Make sure
the On/O switch is in the On position (solid line).
4. For Wired Connections
Connect the ethernet cable to one of the 4 Yellow LAN ports on the
Cradlepoint router. Connect the other end of the ethernet cable to the ethernet
port on your computer. You can connect up to 4 computers using this method.
(Do not use the blue WAN port)
For Wireless (WiFi) Connections
^Using your device’s wireless network connection program, find and connect
to the network name (SSID) listed on the label on top of your router, usually
MBR95-XXX.
^Enter in the password (located on the same label as the SSID).
^Once connected you should be able to surf the internet (there is no splash page).
Cradlepoint
MBR95
AC Power
Supply
USB Modem Ethernet Cable
CRADLEPOINT MBR95 | USER MANUAL Firmware ver. 3.6.3
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 6
2.1 Ports, Buttons, and Switches
CRADLEPOINT MBR95 | USER MANUAL Firmware ver. 3.6.3
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 7
2.2 LEDs
Power:The MBR95 must be powered using an approved 12V DC power source.
702.220.8888
Quick Start Guide|Cradlepoint MBR95+USB Modem
© DataPoint, LLC 2015
4G4RENT.COM

Troubleshooting:
^If you are unable to find your wireless network's name (SSID) in your list of
available wireless networks, your wireless network connection manager may
require you to first manually create/add a network profile. When adding a
network profile, use the network name (SSID) and password located on the
label on top of your router.
^If you loose connectivity, please confirm that everything is plugged in correctly.
Then unplug the routers AC power supply, wait 20-30 seconds, then reconnect
the power. Allow the router to start back up, approximately 3-5 minutes.
^In some instances, cellular "dead zones" exist within an indoor environment.
To help improve the Verizon signal strength, and speed, it may be necessary
to reposition the router away from signal obstructions such as walls or pillars.
To check your speed, visit www.speedtest.net.
702.220.8888
Quick Start Guide|Cradlepoint MBR95+USB Modem
4G4RENT.COM