Creative Play CP055 User manual

HORIZONTAL -
Slatted Bench
Assembly Instructions
IMPORTANT - If foundation are required support legs will be have been extended 450mm
VERTICAL VERSION
REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
pg 1 of 7

REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
pg 2 of 7
PARTS required
x6 (angle cleats/brackets)
x6 (Standard 90x90 L’s)
OPTIONAL - If installed onto tarmac/concrete
NOT REQUIRED IF SUPPORT POSTS HAVE BEEN EXENDED FOR FOUNDATIONS
x24 (80mm brass screws)
x6(40mm brass screws)
x72 (40mm brass screws)
*IMPORTANT - if foundations required additional 450mm included
If freestanding use angle cleats and expansion bolts/excalibur bolts to
secure seats onto tarmac
x6
expansion bolts / excalibur bolts
To be used to secrure seats onto tarmac
BENCH SLATS - QTY 4 (147mm x 47mm)
SLAT SUPPORTS - QTY 3 (90mm x 90mm)
SUPPORTS - QTY 6 (90mm x 90mm)
T1
T2
T3

TOOLS required
REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
pg 3 of 7

REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
SOIL
TIMBER SUPPORT POST
CONCRETE
pg 4 of 7
Foundation Details

If the bench IS pre-assembled JUMP TO STEP
REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
pg 5 of 7
Assembly Instructions
1
2Attach T2 & T3 timber to 90x90 L’s
Using 40mm brass screws
6
T1 T1 T1 T1
T3
T3
T3
T3
T3
T3
T3
T3
T2
T2

REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
pg 6 of 7
Assembly Instructions
3
4
Repeat for the other sets of T2 & T3 timbers
Attach the T1 timbers to the T2 timbers (slat supports)
Using 120mm brass screws
Use 6 screws per SLAT (left/middle/right) ensure they
are uniform
Attach the 2 centre slats first - they sit 2.5mm either
side of the centre (makes the 5mm gap)
T1
T1
T1
T1
*5mm gap between the T1 timbers

REF: CP055 /SBH - HORIZONTAL SLATTED BENCH
pg 7 of 7
Assembly Instructions
5Ensure slats are spaced / arranged as shown
View from below shown
6Install the ASSEMBLED BENCH
Using ANGLE CLEATS with 40mm brass screws and EXPANSION BOLTS or CONCRETE INTO GROUND as per foundation drawings
OR
Position angle cleats on the INSIDE of
each SUPPORT
- Use 40mm brass screws to attach
angle cleat to the support legs
- Use expansion bolts or EXCALIBUR
bolts to secure the bolts to the concrete
/ tarmac
Follow the FOUNDATION DETAILS on
Page 4