Cres Cor CO-151-HW-UA-6B User manual

®
JOB:
ITEM NO:
®
Page E-4.1A
Sept., 2004
AQUATEMP™/ROAST-N-HOLD™
GENTLE CONVECTION OVEN
MODEL CO-151-HW-UA-6B (HALF SIZE)
FEATURES AND BENEFITS:
• Roast, cook, bake, reheat and hold with precise temperature
and humidity control. Slow convected air system promotes
natural browning for flavor and seals in natural juices.
• Moist heat, dry heat or a combination of both allows for a
•variety of food preparation and holding.
• Full 4950 Watts of power allows for reheating of prepared
•meals or bulk items. Maximum temperature 350˚F. (176.5˚C.).
• 1850 Watt water heater with separate control and low
•water indicator.
• Energy Management Logic system electronically directs power
to where it’s needed most during different operating cycles.
• Pre-setting automatic controls for roasting and holding
•cycles allows for unattended operation 24 hours a day.
• Roast and hold over 120 lbs. (54 kg.) of meat in just
•7 sq. ft. of floor space.
• Non-venting oven, permitted by most local codes, provides
•easy, inexpensive installation.
• 304 stainless steel construction throughout for ease
•of cleaning.
• Smooth interior coved corners prevent food particle/grease buildup.
• Field reversible insulated door prevents temperature loss.
Silicone door gasket for proper seal. High temperature ceramic
magnetic latch for “easy open” and security during transport.
Latch and hinges mounted inboard.
• Standard with right hand hinging; left hand hinging
•available upon request.
• Push/pull handle mounted on rear allows easy maneuvering.
• Non-corrosive stainless steel wire universal angles
accommodate a large variety of pan sizes on adjustable
1-1/2" spacing. Supplied with 6 sets of angles and three
raised wire grids.
• Heavy duty 5" swivel casters, two with brakes. Provides
•mobility when fully loaded.
• Probe Power Unit Available at Extra Cost (see page E-6)
POWER UNIT OPTIONS:
• 4950 Watts, 208 Volts, 1 Phase, 60 Hz.
• 4950 Watts, 240 Volts, 1 Phase, 60 Hz.
• 4950 Watts, 208 Volts, 3 Phase, 60 Hz.
• 4950 Watts, 240 Volts, 3 Phase, 60 Hz.
Probe Power Unit Available at Extra Cost (see page E-6)
CO-151-HW-UA-6B
5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: [phone]
www.crescor.com
®
®
®
C
SANITATION
CLASSIFIED
CLASSIFIED TO
NSF4
ACCESSORIES and OPTIONS
(Available at extra cost):
o Security Panel for Controls
o Tempered Glass Door Window
o Key Lock Latch
o Extra Wire Grids
o Extra Universal Angles
o Side and Rear Bumper
o Corner Bumpers
o 50 Cycle Service
oSee page E-10 for accessory details.

5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: [phone]
www.crescor.com
© Crescent Metal Products, Inc. 1998 All rights reserved. Litho in U.S.A.
®
CO-151-HW-UA-6B
In line with its policy to continually improve its products,
CRES COR reserves the right to change materials and
specifications without notice.
SHORT FORM SPECIFICATIONS
Cres Cor AquaTemp Roast-N-Hold Convection Oven Model
CO-151-HW-UA-6B. Removable power unit 20 ga. 304
stainless steel, recessed control panel. Cabinet 22 ga. 304
stainless steel. Stainless steel internal frame; coved corner
interior. 16 ga. stainless steel water reservoir, 4 gallon
capacity. Fiberglass insulation in sides 2”; back, door and
base 1-1/2”. 22 ga. 304 stainless steel door, ceramic
magnetic latch, heavy duty hinges. (6) sets universal angles
for multiple pan sizes and spacing. One piece base .125
aluminum. 5" swivel modulus casters, Delrin bearings. Load
capacity 250 lbs. each. 4950 Watts, Volts, 60 Hz.,
____ Phase. 2 year parts warranty. Provide the following
accessories: ___ ___ ___ UL, CUL, UL
Sanitation listed.
CABINET:
• Body: 22 ga. 304 stainless steel.
• Reinforcement: Internal framework of 16 ga. stainless steel.
• Insulation: Fiberglass, thermal conductivity (K factor) is .23
•at 75˚F. 1-1/2" in back wall, door, base; 2" in side walls.
• Water pan: 4 Gallons; 16 ga. 304 stainless steel with 1850 Watt
•heater and with petcock drain; mounted to base.
• Drip trough: Formed 18 ga. stainless steel; mounted to lower
front of cabinet.
• Air tunnel: 20 ga. stainless steel, lift-out type, mounted
•on rear wall.
• Work top: 18 ga., 304 stainless steel.
BASE:
• One piece construction, .125 aluminum.
• Casters: 5" dia., swivel, modulus tires, 1-1/4 wide, load cap.
•250 lbs. each, temp. range -45˚/+180˚F. Delrin bearings. Front
casters equipped with brakes.
DOOR:
• Field reversible.
• Formed 22 ga. 304 stainless steel.
• Latch: Chrome plated zinc with composite handle, ceramic
•magnetic type; mounted inboard.
• Hinges: Heavy duty chrome plated zinc, mounted inboard.
• Gasket: Perimeter type, silicone.
• Pan stop: Embossed.
PAN SLIDES:
• Stainless steel wire universal angles (.306 dia.) mounted on
•lift-out posts.
• 6 sets of angles adjustable on 1-1/2" centers.
• Grids (3): Nickel chrome plated steel, raised wire 17" x 25".
POWER REQUIREMENTS AVAILABLE:
• 4950 Watts, 208 Volts, 60 Hz., 1 phase, 24 Amps.,
•30 Amp. service.
• 4950 Watts, 240 Volts, 60 Hz., 1 phase, 21 Amps.,
•30 Amp. service.
• 4950 Watts, 208 Volts, 60 Hz., 3 phase, 15 Amps.,
•20 Amp. service.
• 4950 Watts, 240 Volts, 60 Hz., 3 phase, 13 Amps.,
•20 Amp. service.
POWER UNIT COMPONENTS: (refer to above drawing)
• Body: Formed 304 stainless steel with black control panel, recessed
and tilted 7˚.
• Power cord: Permanent, 6 ft., 10/3 ga. with right angle plug.
• Air heaters (3): 2670 Watts each.
• Water heater: 1850 Watts.
• Blower motors (3).
• Vent fans (2).
• Fuses (2): 3 amp.
A) Thermostat (holding): Solid state, room ambient to 250˚F. (121˚C.).
B) Thermostat (cook/retherm): Solid state, room ambient to
350˚F. (176.5˚C.).
C) Thermostat (humidity): Solid state
D) Switch: Lighted ON-OFF rocker type.
E) Timer: 24 hr. digital countdown; infinite memory retention.
F) Pilot light for low water level.
G) Thermometer.
INSTALLATION REQUIREMENTS:
• Check local vent hood codes for mobile Roast-N-Hold ovens.
CRES COR PAN DIM “A” DIM “B” DIM “C” INSIDE DIMENSIONS WEIGHT
MODEL NO. CAP/ANGLES SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT ACT.
6 SEE NOTE IN 28-3/4 37-3/4 43-3/4 21-1/4 26-1/2 28 LBS 321
CO-151-HW-UA-6B SETS BELOW MM 740 960 1115 540 675 715 KG 146
NOTE: Refer to pan size chart at end of section.
ALL CONSTRUCTION IS RIVETED, WELDED AND FINISHED.
DETAIL OF
PAN SLIDE