Crest Audio CVL10TK User manual

PO Box 5658
Brendale QLD
Australia 4500
Customer Support
1800 812 261
www.crest.com.au
AUSTRALIAN OWNED
SPECIFICATIONS
• Powered via USB.
• Connect to suitable USB source
providing 5V D.C, 2A (10W).
(USB Adaptor not included)
• Light termperature: 3000K -
5000K
*Ring light is 10” high as measured from
mounting point to top of the ring.
INCLUDED
Welcome to the 10" Crest ring light kit. Here are the
instructions on how to set-up your kit so you can get on with
creating content.
10” RING
LIGHT
KIT
Think, create, innovate! CVL10TK
Tripod 50cm-210cm
LED ring light
Single phone mount
DSLR camera mount

1 X CAMERA MOUNT
ASSEMBLY
Assembly of the 10" Ring Light Kit is broken down into 4 sections:
Tripod, ring light, phone mount and camera mount.
SECTION 1: TRIPOD
1. Take the folded tripod out of the packaging (Fig. 1).
2. Loosen the base adjustment screw (Fig. 2).
3. Use your hands to gently pull the legs outwards from the centre shaft
(Fig. 3).
4. Adjust the legs until they are spread wide and sit securely on the ground.
Then tighten the base adjustment screw.
5. Loosen the pole screws to extend to your desired height. Then tighten
once height is confirmed (Fig. 4 & 5).
1 X 10" RING LIGHT
STABILISING BARS
BRIGHTNESS +
LIGHTING MODE
BRIGHTNESS -
SWITCH ON/OFF
REMOTE
USB CABLE
+
_

SECTION 2: RING LIGHT
1. Remove the assembled ring light from packaging.
2. Loosen the bottom adjustment screw on the ring light, then attach mount
to top of tripod. Tighten the adjustment screw until the ring mount is
secure (Fig. 2).
3. You can tilt the ring light by loosening the adjustment screw and then
tightening once the ring light is in the desired position (Fig. 3).
4. The light modes and brightness levels can be controlled on the remote.
1 3
1. 2. 3.
1. 2. 3.
4. 5.

1712/
6
PO Box 5658
Brendale QLD
Australia 4500
Customer Support
1800 812 261
www.crest.com.au
AUSTRALIAN OWNED
SECTION 3: PHONE MOUNT
1. Screw the phone mount into the hole on the base of the ring light so that it is
secure.
2. Attach the phone bracket onto the mount either in portrait or landscape position.
Pull spring-loaded side of phone mount and insert your smart phone (Fig. 2).
You may need to remove your phone case for secure insertion into phone mount.
SECTION 4: CAMERA MOUNT
1. Attach the metal camera mount to the camera base first.
2. Attach the camera base to the ring light mount by screwing the double
headed bolt into both the camera mount and the ring light.
3. Tighten the base adjustment ring.
1. 2.