Croydex PA680150E User manual

S&H 084 R05
1
PA680150E
BATTERY OPERATED
INFRARED SOAP DISPENSER
ALL ILLUSTRATIONS OF THE PRODUCT ARE FOR REFERENCE
ONLY. COMPONENTS SUPPLIED WITH INDIVIDUAL PRODUCTS
MAY DIFFER
CONTACT DETAILS
Croydex
Central Way
Andover
Hampshire
SP10 5AW
UK
Tel: [phone]
Email: [e-mail]
www.croydex.com
SECTION 1 - INTRODUCTION
Please follow all assembly and product care instructions to
ensure that your product is assembled safely and retains its high
quality finish.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
SAFETY & PRODUCT CARE
1. DO NOT get water or any other liquids into the
battery compartment as this will damage the unit.
2. DO NOT put under running water. For cleaning use a damp
cloth and wipe dry.
3. ALWAYS ensure the unit is o prior to handling.
4. AVOID placing the unit in direct sunlight or near a
reflective area which may redirect light onto the sensor.
5. For first time use or after refilling, the pump will need to
be primed. Due to various thicknesses of liquids, it will be
necessary to repeat assembly STEP 5 at least 6-12 times until
liquid begins to dispense.
6. This dispenser IS NOT suitable for high trac public areas.
SECTION 2 - ASSEMBLY
1. Snap open the cover of the battery
compartment on the bottom of the dispenser.
Insert 4 AAA alkaline batteries. Close the battery
compartment.
2. Attach the base stand so that the unit sits
slight elevated on the counter top. The base
stand will keep water from entering the battery
compartment. Position the dispenser on a flat,
level surface where it will be used.
(See Fig. 1)
BATTERIES ARE NOT INCLUDED WITH THIS PRODUCT
fig. 1
Spout
Chamber Cap
Stainless Steel Canister
Battery Compartment
Sensor
Minimum Fill
Maximum Fill
Base Stand
PUMP
CHAMBER
H190mm x W105mm

S&H 084 R05
2
SECTION 2 - ASSEMBLY
3. To fill the liquid chamber, turn the chamber
cap counter clockwise and lift to open the liquid
chamber. Add your desired hand soap or sanitiser
into the chamber and fill at least 1/3 full. Wipe up
any spills, do not rinse. Do not use foaming soaps,
mouthwash or liquid soaps with abrasives. Do not
fill with thick cream or lotion. Insert the cap and
turn clockwise to seal.
(See Fig. 2)
fig. 2
4. To turn on, press and hold the on/o button
on top of the dispenser until a red light comes on.
The LED will flash every 10 seconds indicating the
dispenser is on and ready to dispense. Press and
hold to turn o, as needed.
(See Fig. 3)
fig. 3
5. To dispense, position hand directly beneath the
spout in close proximity to the sensor area. A red
light will be on during the dispensing cycle and will
shut o once the cycle is complete.
(See Fig. 4)
fig. 4
6. After turning on, the dispenser volume defaults to 1, the smallest
dispensing amount. The volume setting can be adjusted by clicking the
on/o button. Each click advances the volume from 1 to 2 to 3, then
back to 1. A pause is required between clicks. After clicking, a red light
blinks to the following patterns to confirm the new volume setting;
Volume 1: Long, Short.
Volume 2: Long, Short, Short.
Volume 3: Long, Short, Short, Short.
SECTION 4 - CERTIFICATES OF CONFORMITY
Page 1 of 1Rev 0-May 2018
Croydex is a division of Norcros Group (Holdings) Limited
EU DECLARATION OF CONFORMITY
To the Electromagnetic Compatibility (EMC) Directive
2014/30/EU
1. Description of products:-
PA680150E Battery Operated Infrared Dispenser
2. Directives complied with:-
European Parliament/Council Directive 2014/30/EU on the harmonisation of the laws of
the Member States relating to electromagnetic compatibility (EMC) Directive (recast).
3. Declaration
The products listed above in section 1 conform to the following harmonised standards:
EMC
BS EN 55014-1:2017
BS EN 55014-2:2015
For and on behalf of CROYDEX
P. Pegden
Product and Procurement Director
Date: 16-07-2020
Page 1 of 1Rev 1-July 2019
Croydex is a division of Norcros Group (Holdings) Limited
EU DECLARATION OF CONFORMITY
To the Restriction of Hazardous Substances (RoHS) Directive
2011/65/EU as amended by Commission Delegated Directive
(EU) 2015/863
1. Description of products:-
PA680150E Battery Operated Infrared Dispenser
2. Directives complied with:-
European Council Directive 2011/65/EU of 8 June 2011 on the restriction of the use of
certain hazardous substances in electrical and electronic equipment (recast).
3. Declaration
It is hereby certified that the concentration by weight of the restricted substances in the
homogenous materials in the products described above at section 1 do not exceed the
maximum allowed concentrations listed in European Council Directive 2011/65/EU
Annex II Restricted substances referred to in Article 4(1) and maximum concentration
values tolerated by weight in homogeneous materials, as detailed below:
Substance
Concentration
Lead
0.1%
Mercury
0.1%
Cadmium
0.01%
Hexavalent Chromium
0.1%
PBB (Polybrominated Biphenyls)
0.1%
PBDE ( Polybrominated Diphenyl Ethers)
0.1%
Bis(2-ethylhexyl) phthalate (DEHP)
0.1%
Butyl benzyl phthalate (BBP)
0.1%
Dibutyl phthalate (DBP)
0.1%
Diisobutyl phthalate (DIBP)
0.1%
For and on behalf of CROYDEX
P. Pegden
Product and Procurement Director
Date: 16-07-2020
SECTION 3 - PRODUCT CARE
1. Turn o prior to handling or refilling.
2. Be aware of sensor area to avoid unnecessary dispensing.
3. If the dispenser is spluttering, add more liquid.
4. If blocked, use a toothpick or bend open a paperclip and poke into
the nozzle to dislodge any clogs, test again. If the blockage persists,
empty the liquid chamber by tilting the dispenser backwards and
emptying the contents. Carefully fill with warm water and continue to
cycle the pump until the flow improves. Gel soaps are recommended
to prevent clogs. A small amount of water in soap may improve flow of
regular liquid soaps.
PUMP
MAXIMUM
FILL
MINIMUM
FILL