CTS MCT-RACK-18 User manual

Installation Guide
Version 0.91
1. Package Contents
Power Cord Slider Set x 20 Rubber Foot x 4
Pulling Cable x 1 Chassis x 1
Console Cable x 1(For Management Model Only)
2. Installation
Note: Please wear a grounding device and observe electrostatic discharge precautions before
install into the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS.
2.1 Install GIGABIT/FAST ETHERNET MEDIA CONVERTER
Slide-In Modules
1. Plan the GIGABIT/FAST ETHERNET MEDIA CONVERTER Slide-In Module slot positions
2. Remove the cover plate from selected installation slot
3. Insert GIGABIT/FAST ETHERNET MEDIA CONVERTER Slide-In Module carefully and firmly
into the selected slot
4. Fix the fastener screw.
5. Repeat steps 2 to 4 for all the GIGABIT/FAST ETHERNET MEDIA CONVERTER Slide-In
Module.
6. You may connect the supplied pulling cable with a media converter to pull it out more
easily.
Non-Management Model
For Management model, please refer to User's Manual that comes with the Chassis for panel
overview.
2.2 Install 18 SLOTS MEDIA CONVERTER CENTER CHASSIS
Note: Do not block the bottom of the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS.
2.2.1 Standard Rack Installation
1. Plan the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS rack position
2. Fix both mounting brackets into the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS
3. Align the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS with mounting bracket into the
selected mounting rail position
4. Fix the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS with mounting brackets into the
selected mounting rails position carefully and firmly.
2.2.2 Desk Top Installation
1. Plan the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS desk top position
2. Place the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS on a well ventilated, flat and firmly
desk.
2.3 Connect GIGABIT/FAST ETHERNET MEDIA CONVERTER
slide-in modules to network
Please refer to the User’s Guide that comes with the GIGABIT/FAST ETHERNET MEDIA
CONVERTER slide-in modules for cabling specifications and direction.
Power A
Power B

2.4 Connect Power Supply
Two kinds of optional power connector (DC power or AC power) are available for this Chassis.
Note: Do NOT turn on power source switch before connecting with 18 SLOTS MEDIA
CONVERTER CENTER CHASSIS.
NOTE: Power supply is active and concurrent with internal power supply
For Management model, please refer to User's Guide that comes with the Chassis for power
module installation.
2.4.1 Power On the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS
Procedure
1. Check the power outlet
2. For AC Power Connect the power cord with the power outlet
For DC Power Insert wire positive to switch positive and wire negative to
switch negative
3. Turn on the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS power source
4. Verify the 18 SLOTS MEDIA CONVERTER CENTER CHASSIS status
5. Power LED is on
3. OPERATION
LED Status
18 SLOTS MEDIA CONVERTER CENTER CHASSIS LED (For Non-Management Model)
Power Turn on green when primary power is on
Turn off when primary power is down or fail
For management model, please refer to the User's Guide that comes with the chassis for LED
indications.
GIGABIT/FAST ETHERNET MEDIA CONVERTER Slide-In Modules LED
Please refer to the User's Manual that comes with the GIGABIT/FAST ETHERNET MEDIA
CONVERTER slide-in modules or the chassis for LED indications.
DC POWER Terminal
AC POWER Socket