Cudy GS1010PE User manual

Physical Appearance2
Specifications3
Hardware Connection
1
Working Temperature
Bandwidth
Storage Temperature
Working humidity
Storage humidity
Working hight
Storage hight
-20~50℃
-40~80℃
Max relative humidity 90%, non-condensing
Max relative humidity 95%, non-condensing
Max 10,000 feet（3,000 meters）
Max 10,000 feet（3,000 meters)
Model GS1010PE
Network Protocol
PoE Standard
POE port output
Power Pin
AC Input Voltage
Output
Total Power
Dimension(L×W×H)
Power Socket
Wireless AP Smart VoIP
IP Camera
Powered Device (PD)
Internet
Front board
Back board
PoE Port Ethernet Port
Power input port
IEEE802.3 / IEEE802.3u
IEEE802.3x / IEEE802.3af/at
IEEE802.3at (30W) and IEEE802.3af (15.4w)
DC 48-55V
Power over spare pairs 1/2(+) , 3/6 (-)
AC100~240V
52V ~ 2.3A
120W
222mm*163mm*40mm
NVR Monitor
Router
AC INPUT
MAC Address
Packet Buffer Memory
Forwarding Mode
2K MAC address table
20Gbps (non-blocking)
2M
Store-And-Forward
10-Port Gigabit PoE+ Switch
120 Watts
GS1010PE 2 3 4 5 6 7 8 9 10 PWR1
10/100/1000M PoE/PoE+ Port
10-Port Gigabit PoE+ Switch
120 Watts
GS1010PE 2 3 4 5 6 7 8 9 10 PWR1
10/100/1000M PoE Port

Quick Installation Guide
Model: GS1010PE
810600082
LED and Interface Explanation
4
PWR
Link ACT
Power LED
Link LED
ON
OFF
ON
OFF
Flashing
Powered
No power
Link connected
Link disconnected
Link data transmitted
Email: [e-mail]
For support and warranty, please visit: http://www.cudy.com/. Specifications are subject to change
without notice. Cudy is a registered trademark of Shenzhen Cudy Technologies Co., Ltd. Other
brands and product names are trademarks or registered trademarks of their respective
holders.Copyright©2020 Shenzhen Cudy Technology Co., Ltd. All rights reserved.
EU Address: Otto esser 2c, 65451 Kelsterbach, Germany
EU declaration of conformity
Cudy hereby declares that the device is in compliance with the essential requirements and other
relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.The
original EU declaration of conformity may be found at http://www.cudy.com/
Trouble Shooting
●Make sure the equipment is installed according to the manufactures installation guide.
● Confirm RJ45 cable order meets EIA TIA568A or 568B standard.
● Replace the equipment with a proper functioning PoE Ethernet Switch to check if the equipment
is damaged.
●Please contact your vendor if trouble still exists.
Email:
[e-mail]
Website:
www.cudy.com