Cypress Semiconductor EZ-USB FX2LP User manual

D6
SW2
D1
CY3674 EZ-USB FX1/CY3684 EZ-USB FX2LPTM
DEVELOPMENT KIT QUICK START GUIDE
1 2
3
Step 4: Start the Cypress USB Control Center
•Run the Cypress USB Control Center by
double-clicking the CyControl.exe located at
<Installed Directory>\Windows Applications\
Application Source les\c_sharp\controlcenter\bin\
Release. The CY3684 board appears as Cypress
FX2LP No EEPROM Device and CY3674 board
appears as Cypress FX1 No EEPROM Device in the
left panel of the USB Control Center. Now you can
load rmware images into the board and you can
schedule Data Transfers to FX2LP/FX1using the USB
Control Center. Refer the instructions described in the
User Guide (located at <Installed Directory>\
Documentation) to try examples on the DVK
Step 1: Software Installation
•Download and Install the latest EZ-USB DVK setup
(CY3684Setup.exe) from http://www.cypress.com/
?rID=14321
Note: For rst time users, Cypress recommends accepting
the default options at each stage of the setup
Step 2: Hardware Connection
•Ensure that JP2 (BUS PWR), JP5 (3.3V IN) and JP10
(3.3V) jumpers are installed, and the EEPROM
ENABLE switch (SW2) is in the NO EEPROM
position as shown above
• Connect the B end of the USB cable to the board
and connect the other end to the USB 2.0 receptacle
on a PC / laptop
• LEDs D1 and D6 glow to indicate that the board
is powered
Step 3: Driver Installation
•Drivers are installed automatically. In the Windows
Device Manager, under Universal Serial Bus
Controllers, the CY3684 board appears as Cypress
FX2LP No EEPROM Device and CY3674 board
appears as Cypress FX1 No EEPROM Device
• If automatic driver binding does not happen,
follow the note below to manually bind the driver
Note: Open Windows Device Manger, locate the unknown
device under other devices, and right-click on the device to
select Update Driver. The drivers are located in <Installed
Directory>\Drivers\Win7\x64. Select a driver based on the
operating system. For example, for Win 7 (64-bit), select
win7\x64
4

© 2011 - 2014 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the properties of their respective owners.
Doc.#: 001-67113 Rev.*D
DEVELOPMENT KIT QUICK START GUIDE
P2 GPIO Headers
IDE Connector
P1 GPIO Headers
JP6
GAL22LV10C PLD
GPIO LEDs
Power LED
Type B USB Connector
Keil Monitor Indicator LED
JP7
LTC1386CS Transceiver
P3 GPIO Headers
SW1
SW2
24LC00 EEPROM
24LC128 EEPROM
UART 1 -RS-232
Connector
P4 GPIO Headers
CY7C68013A-128AXC
[CY3684FX2LP DVK]
or CY7C68013-128AXC
[CY3674 FX1 DVK]
P7:40 Pin GPIO
Expansion Port
CY7C1019CV SRAM
UART 2 -RS-232 Connector
Push Buttons
P6 GPIO Headers
PCF8574 IO Expanders
EZ-USB FX1/FX2LP Development Board Details
For the latest information about these kits visit
www.cypress.com/go/CY3684
www.cypress.com/go/CY3674
CY3674 EZ-USB FX1/CY3684 EZ-USB FX2LPTM