Cypress CY3641 User manual

QUICK START GUIDE
CY3641 PROGRAMMING KIT
Kit Contents:
1. CY3641 Programming Board
2. USB Standard-A to Mini-B cable
3. Quick Start Guide (this document)
4. IC CY29412FLXI
(placed inside the socket)
The CY3641 Programming Kit enables quick and easy Programming of Cypress’s
High Performance Programmable Oscillator (CY29411, CY29412)
• Download and install the latest kit software onto
your PC from www.cypress.com/CY364X
• Connect the board to your PC using the provided
USB cable
• The Status LED (Green) turns ON after the kit
driver enumeration is complete
1
Steps to successfully program the clock device
using this Programming kit.
• Ensure default jumpers setting as mentioned
in Table overleaf
• Run the Clock Programmer software tool
1. Select CY294xx from the Device List
2. Select 0x55 for target I
2
C address
3. Click Connect
4. Open the JEDEC le from <Install_Directory>
\CY364x Programming Kit\<version>\Firmware\
CY3641\CY3641 Kit LVPECL 2.5V 156.25MHz)
5. Click Program
• While eFuse programming is underway you
will notice Power LED (LED2) to glow Amber
2
Downloaded from Arrow.com.

QUICK START GUIDE
CY3641 PROGRAMMING KIT
© 2017 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the property of their respective owners.
002-18660 Rev.*A
CY3641 Board Details
Table: Jumpers Default Position
• CY3641 comes with two SMA connectors,
which could be used to measure clock
parameters of the programmed part
• Please refer Section 5 Additional Features
of CY3641 in the Kit Guide for details
Main Power Supply Jumper (J1)
Power LED
Pin1
Termination
Jumper (J5)
Differential
Clock Output
Socket for 8-pin LCC 7mm x 5mm
* Component is on the bottom-side of the Programming Board
USB Mini-B
Connector
Status LED
PSoC 5LP
(CY8C5868LTI-LP039)*
Purpose
Power on CY29412
Jumper
J1
Default
Position
1 - 2
1 - 2
Termination voltage set to GND
J5
3
Downloaded from Arrow.com.