Cypress CY3240-I2USB User manual

CY3240-I2USB BRIDGE KIT
QUICK START GUIDE
Insert I2C-USB Bridge Kit CD. Install kit
contents, PSoC Designer, PSoC Programmer
and Bridge Control Panel.
Remove I2C-USB Bridge from package.
Connect the USB A to Mini B Cable and
the bridge to PC. LED D2(green) lights up.
Plug in the I2C slave demo target board
to header J3 of the bridge board.
Provide input for bridge control panel. LED D3 (red) of demo target board
lights up.
1
2
3
4
5
6
Downloaded from Elcodis.com electronic components distributor

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. DOC#: 001-66748 REV **
www.cypress.com/go/CY3240-I2USB
For the latest information about this kit visit
CY3240-I2USB BRIDGE KIT
QUICK START GUIDE
I2C-USB Bridge Kit Details
Photo Diode Output LEDs
Internal Power Jumper
PSoC CY8C24894 Chip
USB Mini-B Connector
GPIO Pins
ISSP Programming Header
PSoC CY8C21123 Chip
Downloaded from Elcodis.com electronic components distributor