Cypress CY3280-20x66 Universal CapSense User manual

CY3280-20X66 UNIVERSAL CAPSENSE CONTROLLER KIT
QUICK START GUIDE
Remove CY3280-20x66 Universal
CapSense Controller Board from package.
Connect the CY3280-SLM board (to be
purchased separately) to the P2 connector.
Ensure that shunt is placed between 5 V
and VCC of jumper J1. Plug in the USB
cable to the CY3280-20x66 Universal
CapSense Controller Board.
Touch the CapSense button or slider. The
respective LEDs lights up.
Insert the kit CD into the CD drive of your
PC. Install the kit contents, PSoC Designer,
PSoC Programmer, and Bridge Control
Panel. After the kit contents and software
are installed, PSoC Designer can be used
to customize existing example projects or
create new ones.
1
2
3
4

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. DOC#: 001-53020 REV *A
www.cypress.com/go/CY3280-20x66
For the latest information about this kit visit
CY3280-20X66 UNIVERSAL CAPSENSE CONTROLLER KIT
QUICK START GUIDE
DC Supply
Socket
Reset Switch
CapSense Module
Connector
Mini B USB
Connetor
9 V Battery Terminal
LEDs
ISSP Connector
SPI/I2C
Header
Jumper for XRES
Selection
ICE-Cube Debug
Connector
Jumper to Select
Power Option
GPIO Pins
PSoC
CY8C20066A
Variable Voltage
Controller
5 V and Vadj Voltage
Regulator ICs
CY3280-20x66 Universal CapSense Controller Board Details