Cypress PowerPSoC CY3268 User manual

CY3268 POWERPSoC®LIGHTING STARTER KIT
QUICK START GUIDE
Remove the CY3268 PowerPSoC board
from the package.
Plug in the power supply. LED1 (green)
turns ON.
Touch the CapSense buttons CSB1 to CSB4
to turn on the HBLEDs. Touch them again to
select corresponding HBLED.
The respective high brightness LED turns ON.
Touch the CapSense button CSB5 to change the
HBLED brightness. There are 10 brightness levels
for each HBLED.
1. Insert the kit CD in your PC’s CD drive.
2. View the user’s guide.
3. Install the kit contents, PSoC Designer, and
PSoC Programmer..
1
2
3
4
5
6

© 2009-2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. DOC#: 001-49665 REV *E
www.cypress.com/go/CY3268
For the latest information about this kit visit
CY3268 POWERPSoC®LIGHTING STARTER KIT
QUICK START GUIDE
CY3268 PowerPSoC Board Details
OCD
Connector
DC Supply Jack
Power Supply
Indication LED
PowerPSoC
CY8CLED04DOCD1-56LTXI
FN0 Extension
Header
Temperature
Sensor
High Brightness
LEDs
Shielded Power
Inductors
RESET
Switch
ISSP
Programming
Header
CapSense
Buttons
WARNING: HIGH BRIGHTNESS LEDs CAN CAUSE PERMANENT DAMAGE!
Do not look at the HBLEDs directly. The HBLEDs illuminate at a very high intensity and can cause perma-
nent eye damage. Use a thick white sheet of paper as diffuser if there is no optical diffuser available.
WARNING: Generally all lab work in power electronics must be done with extreme care. Caution must be
exercised when using power supplies and/or power related equipment.