Cypress CP-1262HE User manual

CP-1262HE
HDMI to PC/Component
Converter with
Audio Box
CP-1262HE
Operation Manual

1. Introduction................................................................................
2. Features......................................................................................
3. Operation Controls and Functions..........................................
3.1 Front Panel...........................................................................
3.2 Rear Panel............................................................................
4. Connection and Installation.....................................................
5. HDMI Connector Pin Assignment.............................................
6. Specifications.............................................................................
Table Of Contents
1
1
2
2
2
3
3
4

1. Introduction
This converter box converts digital HDMI to Analog PC or SD/HD output. It
enables to connect the HDMI sources to the analog PC monitor, Projector or
TV. Its high bandwidth capability supports a wide range of PC and HDTV
resolutions.
2. Features
 Supports HDMI input and Analog PC or SD/HD output.
 Supports output selection between YPbPr and RGB.
 Supports input/output resolution as below:
PC: 640x480= VGA59 , VGA60, VGA72, VGA75, VGA85
800x600= SVGA56, SVGA60, SVGA72, SVGA75, SVGA85
1024x768= XGA60, XGA70, XGA75, XGA85
1152x864= MAC70, MAC75, MAC85
1280x800= WXGA60
1280x1024= SXGA60, SXGA75, SXGA85,
1440x900= WXGA60
1600x1200= UXGA60
1680x1050=WSXGA+60
1920x1200= WUXGA60(pixel-rate=154MHz)
HD: 480I60, 576I50, 480P60, 576P50, 720P60, 720P50, 1080I60, 1080I50,
1080P60, 1080P50
Note: ①Due to the limitation of Tri-level synchronies output
the image will shift to the left side of the screen when
component output at 720p/1080i/1080p.
②If HDMI source includes HDCP(High-bandwidth Digital
Content Protection), output display is not supports
HDCP decryption and no image will display.
 Built in EDID.
 HDMI 1.3, HDCP 1.1 and DVI compliant.
1

2
1 YPbPr/RGB switch:
Set the switch to RGB when your HDMI source equipment is PC graphic
card or other digital RGB source signal. Use HD-15 to HD-15 VGA cable
to connect between the unit's RGB out and the RGB input of your PC
monitor, or projector. Set the switch to YPbPr when your HDMI source
equipment is DVD player, set-top-box or other High definition digital
video source. Use a VGA to 3 RCA adaptor cable to connect the unit's
YPbPr out to the YPbPr input connector of your HDTV.
Note: When YPbPr output from HD-15 D-Sub the H-pin and V-pin will
remain the signal at the same time.
2 HDMI input: Connect the HDMI input port to the HDMI output port of
your source equipment such as DVD player or set-top-box.
3 Power: Plug the 5VDC power supply into the unit and connect the
adaptor to AC wall outlet.
3. Operation Controls and Functions
3.1 Front Panel
1 2 3
DC 5V
RGB
YPbPr
OUTPUT HDMI INPUT
3.2 Rear Panel
1 HD-15 D-Sub output: Connect the output port to the PC/YPbPr input of
analog PC monitor, Projector or TV.
2 L/R: Stereo audio output via 3.5mm phone jack.
1 2
L/RPC/YPbPr
OUTPUT

3
4. Connection and Installation
HDMI out
DVD or, Set-Top-Box
DVD or, Set-Top-Box
HDMI
HDMI
DVI out
DVI to HDMI adaptor
VGA cable
3.5mm to 2 RCA
audio cable
LCD Monitor/TV Projector
or
HDMI cable
Connection 1(RGB out)
Connection 2 (YPbPr out)
HDMI cable
Audio
D-Sub to 3 RCA cable
YPbPr cable
5. HDMI Connector Pin Assignment
Pin#
1
3
5
7
9
11
13
15
17
19
Pin#
2
4
6
8
10
12
14
16
18
Function Assignment
TMDS Data2+
TMDS Data2-
TMDS Data1 Shield
TMDS Data0+
TMDS Data0-
TMDS Clock Shield
CEC
SCL
DDC/CEC Ground
Hot Plug Detect
Function Assignment
TMDS Data2 Shield
TMDS Data1+
TMDS Data1-
TMDS Data0 Shield
TMDS Clock+
TMDS Clock-
Reserved (N.C. on device)
SDA
+5V Power
Output Format
1
67
11
12131415
2345
10 9 8
1
2
19
18
LCD TV

4
6. Specifications
Up to 225MHz
1 x HDMI
1 x HD-15 D-Sub (RGBHV or YPbPr)
1 x Analog L/R 3.5mm phone jack
RGB: 0.7Vp-p 75ohm
H/V: 3 to 5 Vp-p
Or Y: 1 Vp-p 75ohm
PB/Pr: 0.7 Vp-p 75ohm
PC: 640x480= VGA59 , VGA60, VGA72, VGA75, VGA85
800x600= SVGA56, SVGA60, SVGA72, SVGA75, SVGA85
1024x768= XGA60, XGA70, XGA75, XGA85
1152x864=MAC70, MAC75, MAC85
1280x800=WXGA60
1280x1024= SXGA60, SXGA75, SXGA85,
1440x900=WSXGA60
1600x1200= UXGA60
1680x1050=WSXGA+60
1920x1200= WUXGA60(pixel-rate=154MHz)
HD: 480I60, 576I50, 480P60, 576P50, 720P60, 720P50,
1080I60, 1080I50, 1080P60, 1080P50
PCM2
RGB, YUV
5V/1A DC (US/EU standards, CE/FCC/UL certified)
76(W) x 30(D) x 92(H)
172
Aluminum
Silver
0°C ~ 40°C
2.5W (max)
Operation Frequency
Input Port
Output Ports
Output Signal
Input/Output Resolution
HDMI Audio In
HDMI In Color Space
Power Supply
Dimensions (mm)
Weight(g)
Chassis Material
Silkscreen Color
Operating Temperature
Power Consumption
Part No. Pin No. Description (PC out)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
DB15HD
RED
GREN
BLUE
GND
GND (DDC-RETURN)
GND-RED
GND-GREEN
GND-BLUE
N.C
GND-SYNC
GND
DDC-DATA
H-SYNC
V-SYNC
DDC-CLOCK
Part No. Pin No. Description (HD out)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
DB15HD
Pr
Y
Pb
GND
GND (DDC-RETURN)
GND-Pr
GND-Y
GND-Pb
N.C
GND-SYNC
GND
DDC-DATA
H-SYNC
V-SYNC
DDC-CLOCK
B. Analog VGA output pin
assignment when output switch
set to RGB.
C. Analog VGA output pin assignment
when output switch set to YPbPr.

5

20080818 MPM-CP1262HE
Home page: http://www.cypress.com.tw
CYPRESS TECHNOLOGY CO., LTD.