Cypress Perform PSOC 5LP PROTOTYPING KIT User manual

PSoC® 5LP DEVELOPMENT KIT
QUICK START GUIDE
Remove the PSoC 5LP Development Kit from the
package.
Plug the LCD module into port P8.
Plug the USB cable into your PC and the USB
communications port (J2).
Note: USB Port J2 is the PSoC device's USB communications
port. USB Port J1 is used for program/debug and requires
the appropriate software drivers to be installed.
Vary the R56 potentiometer. The voltage
is displayed with 12-bit resolution on the
LCD module.
Insert the PSoC 5LP Development Kit CD.
Install PSoC Creator and the kit software.
Launch PSoC Creator.
Open the code examples from the Start page.
1
2
3
4
5
6

© 2011-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. Doc#: 001-65815 Rev. *C
www.cypress.com/go/CY8CKIT-050
For the latest information about this kit, visit
PSoC®5LP DEVELOPMENT KIT
QUICK START GUIDE
PSoC 5LP Development Kit Details
Power Adapter 9-V Battery Boost Converter
Input
Communication USB
10-Pin JTAG/SWD/SWO
Debug and Prog Header
On-board
Programming
USB
10-Pin MiniTrace
Connector
Port D (CapSense/
Miscellaneous
Port)
32-kHz Crystal
Port E
(Analog Port)
Variable
Resistor/
Potentiometer
RS-232
Interface
Character LCD Interface Switches/LEDs
Prototyping Area
CapSense
Reset Button
24-MHz Crystal