Cypress PSoC CapSense User manual

PSOC®CAPSENSE®EXPANSION BOARD KIT
QUICK START GUIDE
Install Software
1. Insert the kit DVD.
2. Install PSoC Creator, PSoC Programmer,
and the kit project software.
Board Setup for PSoC Development Kit
1. Install the CY8C38 Family Processor
Module on the PSoC Development Kit.
2. Connect MiniProg3 to the CY8C38
Family Processor Module.
3. Ensure default settings are configured
and power the PSoC Development Kit.
Program the PSoC Device
1. Open BMM_USB_KIT-001 code example
from the PSoC Creator start page.
2. Click the Program icon in PSoC Creator to
program the board.
3. Unplug MiniProg3 and disconnect power
from the board.
4. Connect a jumper wire from P1[6] to LED1.
5. Connect a USB cable from the USB
connector J9 to your PC.
Test PSoC CapSense Expansion Board Kit
1. Connect J1 of PSoC CapSense Expansion
Board kit to Port A of PSoC Development
Kit; connect J2 to Matrix Button Module
Kit.
2. Power the PSoC Development Kit and wait
for USB Enumeration LED, LED1 to turn
on. Refer to UG in install location
<Install_Directory>:\PSoC CapSense
EBK\<version>\Documentation for more
details
3. Touch a button; the corresponding row and
column LEDs turn on.
1
2
3
4

© 2011-2013 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. Doc.#: 001-66478 Rev. *B
http://www.cypress.com/go/CY8CKIT-031
For the latest information about this kit, visit
PSOC®CAPSENSE®EXPANSION BOARD KIT
QUICK START GUIDE
Programming with PSoC 3 Development Kit
1. Plug the USB cable into your PC and to J1
of the PSoC 3 Development Kit.
2. Open BMM_USB_KIT-030 code example
from the PSoC Creator start page.
3. Click the Program icon in PSoC Creator to
program the board.
4. Unplug the USB cable to disconnect power
from the board.
Note: Connect jumper J2 on the Matrix Button
Module board to SHLD.
Test PSoC CapSense EBK with PSoC 3
DVK
1. Connect J1 of the PSoC CapSense
Expansion Board Kit to Port D of the
PSoC 3 Development Kit; connect J2 to the
Matrix Button Module Kit. Remove the
LCD from the development kit to avoid
parasitic capacitance.
2. Connect the USB cable to J2 of the PSoC 3
Development Kit and wait for USB
Enumeration LED, LED4 to turn on. Refer
to UG mentioned in step 4 for more details.
3. Touch a button; the corresponding row and
column LEDs turn on.
CY8CKIT-031 Hardware Overview and Features
5
6
2x20-Pin
Connector for
DVK Interface
2x22-Pin
Connector for
CapSense
Interface
1x5-Pin Connector for I2C Interface