Cypress CY4607 HX2VL User manual

HX2VL DEVELOPMENT KIT
QUICK START GUIDE
Insert the kit CD into the CD drive of your
PC. Review kit contents.
Plug the wall mounted power supply into an
AC power receptacle providing power in the
range 100 V to 240 V, 50 Hz or 60 Hz.
Connect the power supply plug to the hub’s
‘DC Supply’ jack.
To connect to the PC, plug the USB A to B
cable into the hub’s upstream connector.
Plug the other end of the cable into one of
the PC’s host controller ports.
The hub is now ready for any low speed, full
speed, or high speed devices to be plugged
into the ports. The four ports on the hub are
labeled Port 1, Port 2, Port 3, and Port 4.
Connect a USB device to any of the four
downstream ports. Use jumpers J7 to J10
(port status) in position 2 or 3 to enable the
port LEDs. The green LED indicates that the
port is enabled.
The amber LED indicates that the port has an
exception condition. The operating system
commands the HX2VL to turn off the port and
set the amber LED until the condition is
cleared.
1
2
3
4
All manuals and user guides at all-guides.com

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of
their respective owners. Doc #: 001-73201 Rev. **
http://www.cypress.com/?id=3624
For the latest information about this kit, visit
HX2VL DEVELOPMENT KIT
QUICK START GUIDE
HX2VL-CY4607 Development Board Details
HX2VL-CY4608 Development Board Details
Port LEDs
Downstream
USB Ports
HX2VL Device
DC Supply Jack
Power LED
Upstream USB
Connector
EEPROM
EEPROM
All manuals and user guides at all-guides.com