Cypress CY14NVSRAMKIT-001 User manual

CY14NVSRAMKIT-001
nvSRAM DEVELOPMENT KIT
CY14NVSRAMKIT-001 Features:
• 16-Mbit (1Mx16), parallel nvSRAM with RTC
• SK-FM4-U120-9B560 compatible headers
• 3.3 V VCC Power Supply
• VCC POWER (LED1) and INT/INT1 STATUS (LED2) LEDs
• Test points for HSB (HSB#, HSB1#) and RTC (INT, INT1)
• 0.1 Farad super capacitor provides RTC backup for
more than two days
SK-FM4-U120-9B560
compatible header
SK-FM4-U120-9B560
compatible header
RTC Backup
0.1 Farad Cap
Test
Points
INT/INT1
STATUS LED
(LED2)
VCC POWER LED
(LED1) 32.768 kHz
RTC Crystal
16-Mbit nvSRAM,
with RTC, 165 FBGA

CY14NVSRAMKIT-001
nvSRAM DEVELOPMENT KIT
• This kit is designed for use with Cypress’s FM4 MCU Evaluation
Board (SK-FM4-U120-9B560)
• Download the kit installer and documentation from
www.cypress.com/CY14NVSRAMKIT-001
• Congure the MCU for program. Upon successful programming,
congure the MCU for run. Refer to the Kit Operation chapter 4 in
CY14NVSRAMKIT-001 User Guide for the MCU congurations
• Ensure J15 on the MCU is congured in the 3V position, for the
3.3 V operation before connecting the kit to the MCU
• Connect the kit to the MCU as shown below
• Power up the board via the USB connection (CN4). LED2 on the MCU and
LED1 on the CY14NVSRAMKIT-001 board will glow Green. LED2 (INT/INT1)
on the CY14NVSRAMKIT-001 board is factory programmed to blink at the
rate of 1-Hz. Run the kit software to evaluate nvSRAM features
© 2015 Cypress Semiconductor Corporation.
All rights reserved. All trademarks or registered
trademarks referenced herein are the properties
of their respective owners. 002-00103 Rev.**
J15
LED2
LED2 (INT/INT1)
LED1