Cypress PSOC 1 Series User manual

CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit
Quick Start Guide
Install Software
1. Insert the CY3215A-DK CD/DVD into the
CD/DVD drive of your PC.
2. Install the kit contents, PSoC Programmer,
and PSoC Designer.
Note: After installation, follow instructions
in step 2 to debug using pod kit OR follow
the instructions in steps 3 and 4 to program
PSoC 1 based target board.
Use Pod to Debug
1. Attach the flex cable and pod to the
ICE-Cube (ICE base unit).
2. Create a project in PSoC Designer and
start debugging.
Note: Pod Kit needs to be purchased
separately. Visit www.cypress.com/go/
shop to find the latest list of Pods.
To Program Target Boards
1. Attach the backward compatibility
adapter to the ICE-Cube in the place
of the flex-pod.
2. Connect the RJ45 end of the ISSP
cable into the adapter.
3. Connect the 5-pin connector of the ISSP
cable to your PSoC 1 based target
board's ISSP header.
4. Program the parts using PSoC Programmer.
1
2
3
4

© 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. Doc.#: 001-80388 Rev. **
www.cypress.com/go/CY3215A-DK
For the latest information about this kit, visit
CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit
Quick Start Guide
For assistance, go to http://www.cypress.com/go/support, or contact our customer support at
[phone] Ext. 8 (in the USA) or [phone] Ext. 8 (International).
CY3215A-DK Kit Details
ISSP Cable
ICE Base Unit
Blue Cat 5e Cable
CY3250
Flex Cable
Backward
Compatibility
Adapter
European
Plug Adapter
USB 2.0 Cable
12-V 1-A
Adapter