D-Link DSL-200 User manual

1
Contents
1. Uninstall previous driver
2. Install new driver
3. Authentication/log in procedure
1. Uninstall Previous Driver
Note: Do not unplug the DSL 200 until prompted
a. Click on the Start button located in the bottom left corner. Select All
Programs then Dlink DSL200 ADSL Modem. Now click on Uninstall
Dlink DSL 200 RevA
Configuring in Layer2 PPPoE
for Windows XP and 2000
Please ensure you have the installation CD that came with your modem. You
will need this when reinstalling the drivers.
If you have misplaced this CD please download the driver from
http://www.dlink.com.au/tech/ before you begin

2
b. Click Yes to “Are you sure you want to remove the software?”
c. Click OK to “Please don’t unplug the USB cable until after the setup wizard
has finished”
d. Now unplug the DSL200 from your computer. Click OK to “Please unplug
the modem from the computer now”.
e. Click Yes, reboot the computer now then click Finish to restart your computer.
2. Install New Driver

3
a. Insert the DSL-200 CD into your PC’s CD-ROM drive.
b. Click on Install Driver to begin the driver installation. If the below screen
doesn’t automatically appear, then from your desktop click on the Start
button located in the bottom left corner, select Run, then type
d:\driver\setup.exe – where d: is the letter of your CD-ROM drive. Then click
on Install Driver.
c. Click Next on the Welcome to D-LINK DSL-200 Modem Setup window.
d. Select Other Service Provider form the list the click on Next

4
e. Select WAN driver then click on Next

5
f. Leave VPI: 8and VCI: 35
Select Encapsulation: RFC 2516 PPPoE LLC Encapsulation
Modulation: Multimode (for ADSL2+ customers) or G.dmt (for ADSL
customers)
Click on Next
g. You will see a confirmation screen with your settings. Click Next

6
h. Depending on you computers settings you may encounter the Software
Installation window. If you do click Continue Anyway, otherwise go to the
next step
i. Click the Finish button on the Setup Complete window.
j. You will see the following DSL Installer window. Plug your modem into a
free USB Port now.
k. Please wait while the software loads

7
l. Click Yes to restart your computer
3. Authentication/log in Procedure
Please ensure that you have restarted your PC before proceeding with the
login procedures.
a. On your desktop, a new icon will appear called D-link PPPoE Au
Connection. Double click this icon to open the Connect DLink PPPoE AU
Connection window.
b. Fill in the User name and Password fields
•User name:
-<TPGusername>@L2TP.tpg.com.au for Fixed IP plans
OR
-<TPGusername>@PPP.tpg.com.au for Dynamic IP plans
(e.g. [email protected])
•Your Password by default is the same as your <TPGusername>
however if you have changed your password since registration
time, please use your current TPG password
•Tick Save this user name and password for the following
users: Me only
c. Click on Dial to connect your ADSL connection

8
d. Your network configuration has now been completed and you can start to
use TPG’s service. After the login procedure, you will be assigned an IP
address and DNS settings from TPG
e. To browse web sites, please now launch your browser
Please note: Before you can use the Internet, you must ensure you
authenticate every time your computer is switched on
Support Information
For further assistance regarding configuration,
please call TPG Technical Support on 1300 360 855
Technical Support Opening Hours
Monday to Friday 8am – midnight
Saturday and Sunday 9am – 9pm
Public Holidays 9am – 6pm