D-Link DSL-224 User manual

Setup Guide for the DSL-224
Step 1: Open your Internet browser (ex. Internet Explorer, Mozilla, Google Chrome, Safari) and
type in the Routers IP address in the address bar and press enter. (Default IP 10.0.0.2).
Step 2: Type in the User Account Credentials for the router. By default the Username is: admin and
the Password is: admin
Step 3: Click on Internet setup, Channel Config. Select the WAN Physical type as “Ethernet WAN”
Note: once interface has been selected, unit will restart to load correct interface.

Setup Guide for the DSL-224
Step 4: After the unit has loaded the correct interface, Scroll down to the WAN table. Select the
circular tick box to edit the default account.
Step 5: Scroll up to the Channel configuration and modify the default configuration with
the username and password provided by your ISP
Channel mode: PPPoE
Enable NAPT: Enabled by default
Enable Firewall: Enabled by default
802.1q: Disable (Enabled by default)
IP Protocol: IPv4/IPv6
PPP setting Username and Password. Please enter details provided by ISP (Default is
guest@telkomadsl and guest).
Step 6: Click on modify to apply the new settings.

Setup Guide for the DSL-224