D-Link DCS-8325LH User manual

2 Мп беспроводная интеллектуальная облачная сетевая
Full HD-камера с ИК-подсветкой до 5 м и слотом microSD
DCS-8325LH
Краткое руководство по установке
Smart Full HD Wi-Fi Camera
Quick Installation Guide

DCS-8325LH
2
Power Adapter
Smart Full HD Wi-Fi Camera
2 x Screws
2 x Wall Anchors
Quick Start Guide
Alignment Sticker

DCS-8325LH
3
Search for mydlink and download the app.
Note: This product is incompatible with other mydlink
apps such as‘mydlink Home,’ ‘mydlink Lite,’etc.
Download the App
1
mydlink

DCS-8325LH
4
Sign In or Sign Up for a mydlink account.
mydlink Lite users may sign in with the same
account.
Log In
2

DCS-8325LH
5
Tap the menu button then tap Add a
Device.Scan the Setup Code on the device,
then follow the app instructions.
Add the Device
3

DCS-8325LH
6
iDevice Information
LED Behavior
Connected to Wi-Fi and mydlink
Status LED
Powering on / Resetting
Ready for set up / Disconnected
Upgrading firmware - do not power off

DCS-8325LH
7
Place the camera at least 2 meters from the ground. The
viewing distance for Person Detection is between 2 - 5
meters.
Placement
2 m
69o
2 m
min
120o
5 m
max

DCS-8325LH
8
Mounting
1/Stick the alignment sticker
where you would like to
place the camera.
2/Use a 6 mm drill bit to drill
two 25 mm deep holes as
indicated on the alignment
sticker.
3/Hammer in the plastic wall
anchors to support the
screws.
2.6~3.0mm
2.6~3.0mm
2.6~3.0mm

DCS-8325LH
9
Mounting
4/Twist the screws into the
anchors, leaving the tops
of the screws exposed
from the surface. Do not
over tighten the screws.
5/Align the mounting holes
on the bottom of the
camera with the screws.
Slide the camera down to
lock it into place.
6/Twist the camera to your
desired position. Go to the
settings in the app and
enable Invert Image if the
image is upside down.
2.6 ~ 3.0 mm
2.6~3.0mm
2.6~3.0mm

DCS-8325LH
10
?FAQ
What do I do if my device is not working properly?
Reset the device and reinstall it. To reset your device, use a paper clip to
press and hold the recessed Reset button until the LED turns solid red.
During installation, ensure that:
• your router is connected to the Internet and has Wi-Fi enabled
• your mobile device is connected to your router Wi-Fi and has
Bluetooth enabled
• your mydlink device is in range of your Wi-Fi network
Why is there a white haze when viewing in night vision mode?
When viewing in night vision mode, the IR lights on your camera may
be reflecting off a nearby surface. Try repositioning your camera to
avoid glare from IR LEDs.
How can I use voice commands to control my device?
The device will work with both Amazon Alexa and the Google Assistant.
For setup instructions on these services, visit the following websites:
Alexa:
dlink.com/en/alexa
The Google Assistant:
dlink.com/en/google-assistant
Why is my microSD card not working/not supported?
The microSD card must be formatted into the correct file system (FAT32)
before it can be used with this product. This can be done in the mydlink
app by selecting the Format function in the storage menu under the
Device settings.