D-Link DGS-F1210 Series User manual

PRODUCT QUICK INSTALLATION GUIDE
DGS-F1210-10PS-E
DGS-F1210-18PS-E
DGS-F1210-26PS-E
DGS-F1210-26MPS-E

1.1 Package Contents
The package contains the following items:
•PoE Switch
•Power Cord
•19” Rack Mounting Kit
•Quick Installation Guide
1.2 Safety Instructions
Use the following safety guidelines to ensure your own personal safety and to help
protect your equipment from potential damage.
•The power cable should be disconnected from the mains during the installation process;
•Wear a grounded anti-static wrist band to avoid the build-up of static electricity;
•Power the product only from the type of external power source indicated on the electrical
ratings label;
•Observe extension cable and power strip ratings. Make sure that the total ampere rating of all
products plugged into the extension cable or power strip does not exceed 80 percent of the
ampere ratings limit for the extension cable or power strip;
To avoid the risk of electric shock, do not open the Switch housing.
•Do not use damaged power cords. Do not modify power cables or plugs.
1.3 Connecting Power
Connect one end of the power cord to the rear of the Switch, and the other end to the mains power
outlet.

1.4 Product Connection Diagram
Front Panel
(The number of RJ45 ports varies depending on model)
1 –Shortcut buttons (DIP Switches)
2 –LEDs
3 –Console port
4 –Reset button
5 –RJ45 PoE ports with Long Reach option (up to 250m)
6 –RJ45 PoE ports
7 –SFP ports

1.5 Product Installation
The Switch can be installed on a desktop, shelf or mounted in a standard 19-inch Rack.
To install the Switch in a rack, attach the supplied mounting brackets to the side of the Switch and
fasten the brackets to the sides of the Switch using the screws from the Switch mounting kit.
Align the brackets and rack holes. Fasten each bracket to the rack.

1.6 Shortcut Buttons (DIP Switches)
Some Switch settings can be applied using the Shortcut Buttons (DIP Switches), without the need to
log into the Switch interface.
DIP Switch
Function when in ON position
AI QOS
Improve video data processing capabilities and improve the monitoring of
Caton and Mosaic phenomena on the network.
AI Extend
Set ports 1 to 8 rate to 10Mbps, but the transmission distance increases
up to 250 meters.
AI VLAN
Isolate RJ45 ports (1-8), (1-16), (1-24) from each other, suppress network
storms and improve network performance. Uplink ports (9-10), (17-18),
(25-26) continue to communicate with all ports.
AI PoE
Automatically restart a remote device by disabling and re-enabling PoE on
the port if it detects the remote device has locked up (no incoming traffic).
1.7 Web-based Management Interface
In order to login and configure the Switch via an Ethernet connection, the PC must have an IP address
in the same range as the Switch. For example, if the Switch has an IP address of 192.168.254.1, the PC
should have an IP address of 192.168.254.x (where x is a number between 2 and 254), with subnet
mask of 255.255.255.0.
The default IP address of the Switch is 192.168.254.1
Open your web browser and enter http://192.168.254.1 in the address bar. Then press <Enter>.
The default username is “admin”, the default password is “admin”.
It is recommended to apply a secure strong password to “admin” account under System Settings >>
User Management.