D-Link DAP-1620 Manual

Technical Support Setup Procedure
Page | 1
How to configure DAP-1620 as Access Point with default wireless
SSID?
Note:
a) Please ensure the device LED is blinking orange colour before you do setup.
b) If it is not blinking in orange colour, follow the guide on page 3 on how to reset
the device before follow the guide to setup.
How Setup DAP-1620 as Access Point? – Goto Page 2
How to reset the DAP-1620? – Goto Page 3

Technical Support Setup Procedure
Page | 2
How Setup DAP-1620 as Access Point?
Step 1: Copy down the wireless name and password that was on the sticker of the device.
Step 2:
a) Plug DAP-1620 direct to power outlet
b) Connect LAN Cable from DAP-1620 to LAN port of the Router.
Step 3: Click on the Computer Icon on the right bottom side of the Windows. Select the
Wireless network name that was copy down.
Step 4: Enter the Wifi Password which had copy down earlier on. Click on OK.
--- END ---

Technical Support Setup Procedure
Page | 3
How to reset DAP-1620?
Step 1: Plug DAP-1620 direct to power outlet.
Step 2: Power on DAP-1620 and wait for 1 min.
Step 3: Use a paper clip to press and hold the Reset Button for 30 second.
Step 4: Wait for 2 min for the device to fully power on after reset.
--- END ---