D-Link DAP-1365 Manual

Technical Support Setup Procedure
Page | 1
How to configure DAP-1365 as Access Point with default
wireless SSID?
(Note: Please ensure the device LED is blinking orange colour before you do setup.
If it is not blinking in orange colour, follow the guide on page 3 on how to reset the device
before follow the guide to setup.)
Step 1: Copy down the wireless name and password that was on the sticker of the device.
Step 2: a) Plug DAP-1365 direct to power outlet.
b) Connect LAN Cable from DAP-1365 to LAN port of the Router.
Step 3: Click on the Computer Icon on the right bottom side of the Windows.
Step 4: Select the Wireless network name that was copy down.

Technical Support Setup Procedure
Page | 2
Step 5: Enter the Wifi Password which had copy down earlier on. Click on OK.
Step 6: You are now connected to the DAP-1365 and use the internet.
--- END ---

Technical Support Setup Procedure
Page | 3
How to reset DAP-1365.
Step 1: Plug DAP-1365 direct to power outlet.
Step 2: Power on DAP-1365 and wait for 1 min.
Step 3: Use a paper clip to press and hold the Reset Button for 30 second.
Step 4: Wait for 2 min for the device to fully power on after reset.
--- END ---