D-Link DAP-3220 User manual

WIRELESS 108G EXTERIOR ACCESS POINT
DAP-3220
Quick Installation Guide+
Руководство по быстрой установке+
Guía de Instalación Rápida+
Guia de Instalação Rápida+
快速安裝指南+
Petunjuk Pemasangan Cepat+

Quick Installation Guide
Wireless 108G Exterior Access Point
DAP-3220

3
DAP-3220 Wireless 108 G
Exterior Access Point
Using a power adapter with a different
voltage rating will damage and void the
warranty of this product.
System Requirements
Minimum System Requirements:
• CD-ROM Drive
• Computers with Windows®, Macintosh®, or Linux-based
operating systems
• Installed Ethernet Adapter Internet Explorer version 6.0 or Netscape
Navigator™version 7.0 and above
Power over Ethernet
base unit
CD-ROM with Manual
Power Adapter - DC 48V, 0.4A
Mounting Plate
4m Ethernet Cable Power cord
Screws Grounding Wire
Package Contents

4
This product should ONLY be installed by an experienced installer
who is familliar with local building and safety codes and where ever
applicable, is licensed by the appropriate authorities. Failure to do so
may void the D-Link product warranty and may expose the end user
or the service provider to legal and nancial liabilities. D-Link and its
resellers or distributors are not liable for injury, damage, or violation of
regulations associated with the installation of outdoor units or antennas.
Asafety grounding system is necessary to protect your outdoor installation
from lightning strikes and the build-up of static electricity. The grounding
system must comply with theNationalElectricalCodeandsafetystandards
that apply in your country. Always check with a qualied electrician if you
are in doubt as to whether your outdoor installation is properly grounded.
Important Information
It’s besttouseacomputer(withan Ethernetadapter) connectedto aswitch
to congure the DAP-3220. The default IP address for the DAP-3220 is
192.168.0.50 with a subnet mask of 255.255.255.0 on the wired Ethernet
side. You will need to assign your computer a static IP address within the
same range as the DAP-3220’s IP address for the purpose of conguring
the DAP-3220. If you need assistance assigning a static IP address
to your network adapter, please refer to the manual on the CD-ROM.
Before You Begin

5
Physical Installation
Connect the supplied
Ethernet cable with the
waterproof enclosure to
the Ethernet port on the
DAP-3220 and attach the
grounding wire.

6
Step 1: Insert provided wall anchors in the wall where the mounting plate will be
attached.
Mounting Plate Assembly
Step 2: Use the provided screws to secure the mounting plate on the wall.

7
Step 3: Attach the remaining screws securely to the back of the
DAP-3220.
Step 4: Attach the DAP-3220 to the mounting plate.

8
Step 5: Slide the DAP-3220 down into the grooves on the mounting plate to secure
it to the plate.

9
Installing the Hardware
Step 1
Step 2
Connect one end of an Etherne cable (included with your package)
to the LAN port on the DAP-3220 and the other end of the Ethernet
cable to the port labeled P+DATA OUT on the PoE base unit.
Connect another Ethernet cable from the DATA IN port on the PoE
base unit to your router/switch or to a PC.
Attach the power adapter to the connector labeled POWER IN on the PoE base unit.
Attach the power cord to the power adapter and into an electrical outlet.
Step 3

10
When you have completed the steps in this Installation Guide and congured your
DAP-3220 for your network, your network should look similar to this:
Your Setup is Complete