
BRC2E52C7 / BRC3E52C7 Operation manual
4P368042-1 - 2014.02 8
Names and Functions
1.Operation Mode Selector button
•Only available on the BRC2E
•Press this button to select the operation
mode of your preference. (See "Cool/Heat/
Auto/Fan Operation" on page 13)
•Available modes may vary with the
connected model.
2.Fan Speed button
•Used to change the fan speed. (See "Cool/
Heat/Auto/Fan Operation" on page 13)
•Available fan speeds may vary with the
connected model.
3.Menu/Enter button
•This button is disabled by default.
To enable, refer to "Enable/disable the
Menu/Enter and Cancel button" on
page 12.
•Used to display the Main Menu or enter the
selected item (See "The Main Menu Items
Overview." on page 23).
4.Up button
•Used to raise the set temperature.
•The next item on the upper side will be
highlighted.
(Keep pressing the button to cycle through
the values or items).
•Used to change the selected item.
5.Down button
•Used to lower the set temperature.
•The next item on the lower side will be
highlighted.
(Keep pressing the button to cycle through
the values or items).
•Used to change the selected item.
6.Right button
•Used to highlight the next items on the
right-hand side.
•The display contents are changed to the
next screen.
7.Left button
•Used to highlight the next items on the
left-hand side.
•The display contents are changed to the
previous screen.
8.ON/OFF button
•Press to start or stop the air conditioner.
9.Operation lamp (Green)
•This lamp lights up during operation.
•This lamp is not lit when the unit operation
is OFF.
•This lamp blinks if an error occurs.
10.Cancel button
•This button is disabled by default.
To enable, refer to "Enable/disable the
Menu/Enter and Cancel button" on
page 12.
•Used to return to the previous screen.
11.LCD (with backlight)
•The backlight will be lit for approximately
30 seconds when one of the buttons is
pressed.
•The actions linked to the buttons , except
for the ON/OFF button, are not carried out
when the backlight is not lit.
•When two remote controllers are used to
control a single indoor unit, the backlight of
the remote controller which is operated rst
will be lit.