
6
OPERATION
6. Seat Vibration: at any point during the Neck, Back, or Auto Massage,
press to add soothing vibration to your glutes and the back of your
thighs. Each press will cycle through one of the three vibration settings
(Low, Medium, High), and pressing a fourth time well exit the Seat
Vibration mode.
7. Heat Function: To activate the unit’s heat function at any time, press .
Press a second time to turn off this function.
8. To shut down the unit at any time, press . Massage nodes will travel
back to their default location and spin several times before powering off.
COMBINING FUNCTIONS
1. While Auto Massage is NOT in progress, the Neck Massage, Back
Massage, Seat Vibration, and Heat settings can all be used separately or
together, in any combination.
2. While an Auto Massage is in progress, the neck massage adjustment
buttons and the spot massage function will all be temporarily unavailable.
3. During a preprogrammed Auto Massage Mode (I, II, or III) massage,
pressing or any of the back massage function buttons
[ / / ] will exit Auto Massage and restart the timer.
5
OPERATION
5. For a pre-programmed Back Massage: choose one of the three Auto
Massage programs, which will cause the massage nodes to travel up and
down your back in preset patterns.
a. Press to cycle through the Auto Massage programs, which
will illuminate the display on the top of the remote. After cycling
through Program I, II, and III, the fourth press will exit Auto
Massage mode.
1. Unfold the unit and place it onto your desired seat. Use the attached strap
to affix the unit to the back of the seat. Plug power adapter into a standard
power outlet (or use the car adapter). Sit down onto the cushion and lean
back comfortably.
2. Press to turn on massager. Massage nodes will reset.
3. For an adjustable Neck Massage: recline back, resting your neck
comfortably onto the neck cushion, and press .
a. The arrow buttons on the remote allow you to adjust the position
of the massage nodes along your neck and shoulders.
b. Press and hold or , and release when the nodes
reach your desired location.
c. Press any time during the neck massage to turn it off.
4. For a tapping and kneading Back Massage: choose one of the
corresponding area buttons, which will illuminate the display at the top of
the remote.
a. Press Upper to target the upper back, Lower to target
the lower back/lumbar, and Full for a massage that runs the
full length of the spine.
b. For a Point Massage, which will target a single point on your back,
press when the massage nodes are at your desired location,
and the unit will stay in that one place until you press again.