Dakota Digital VHX-66F-BRO User manual

Manual #650363
VHX-66F-BRO
Dakota Digital VHX Instrument Installation
For 1961-’66 Ford pickup
1966-‘77 Ford Bronco
Your new VHX-66F-BRO kit should include:
Control Box
CAT5 Cable
(Connects Display
to Control Box)
Universal Sender
Pack
Installation Manuals
VHX Display
8-32 Screws
Ford Speed
Sender

Manual #650363
Installation
1. Remove the stock gauges from the dash. Remove the four screws holding the gauges cluster to the
dash. These screws will be re-used for the VHX installation.
*F100 Owners: Remove the four screws from the dash to remove the stock gauges. Skip to step 6.

Manual #650363
2. Remove these four screws to separate the bezel from the gauges.
3. Remove the gauges, separator plate, and lens. The only part that will be re-used is the stamped
bezel. Now is a good time to clean the bezel.

Manual #650363
4. Remove the protective tape from the
clear lens and install the VHX system
into the bezel. Watch carefully as you
insert the system so you don’t scratch or
damage the lens.
5. Secure the VHX system to the bezel with the four supplied 8-32 screws.
The VHX system should align tightly and sit flush with the bezel.

Manual #650363
6. Connect the CAT5 cable to the system so it
can be routed and connected to the control
box as the system is re-installed
6. Install system with original bezel back into
the dash with these four original screws
*F100 Owners: Install the system into the dash using the four supplied 8-32 screws.

Manual #650363
4510 W. 61st St. N., Sioux Falls SD 57107
Phone: [phone] Fax: [phone]
www.dakotadigital.com
[e-mail]
7. Re-install the cluster into the truck and refer to the main manual for
wiring instructions to complete the VHX installation.