Dakota Digital VHX-1016 User manual

Manual # 650438A
VHX-1016
Dakota Digital Universal VHX Instrument Installation
Your new VHX-1016 kit includes:
Installation
Control Box
(2x) U-Brackets
(4x) Thumb Nuts
CAT5 Cable
Universal Sender Pack
Installation Manuals
and Cutout Template
VHX Display
1. Use the provided template to mark out the opening needed to fit the VHX display. Ensure there is
adequate clearance behind the desired mounting location. The display unit needs approximately two
inches of depth behind the dash. The overall bezel size is shown below.
Switch Assembly

Manual # 650438A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
2. With the appropriate opening cut, place
the VHX display into the dash and attach
the two (2) U-brackets to the back of the
display using the provided thumb nuts.
3. Attach the provided CAT5 Cable to the back of
the VHX display and carefully route the other
end to the control box mounting location and
refer to the main manual for wiring instructions.