Dakota Digital HDX-68C-VET User manual

Manual # 650651
HDX-68C-VET
Dakota Digital HDX Instrument Installation
For 1968-’77 Corvettes
Your new HDX-68C-VET kit includes:
Installation
Control Box
(2) Mounting Brackets
(2) Thumb Nuts
Universal Sender
Pack
Installation Manuals
HDX Displays
1. Remove the stock gauge clusters from the dash and save all hardware for reassembly.
(3) Block-Off Lenses
Clock Harness
Extended Mounting
Bracket
Washer
Interconnect
Harness
Y Harness
(2) Main Harnesses

Manual # 650651
2. Remove the stock gauges, separator plate, and lenses from the bezels. For the main cluster,
reattach the lens spacer to the bezel after removing the lens as shown. The only items to be
reused are the original front bezels and gauge mounting hardware.
3A. The speedometer and tachometer are interchangeable side to side. Choose the orientation you
prefer, then place the speed and tach on the main lens spacers and secure the gauges with the
six (6) stock mounting screws. Use two (2) stock mounting screws to attach the ABS plastic
brackets to the bezel and thumb screws to secure the brackets to the HDX gauges.
3B. Dashes with the vent by the driver’s right knee
will use the extended ABS bracket for proper
Mounting.

Manual # 650651
5. Peel the paper off the two block-off lenses needed for the back of the housing appropriate
for your vehicle. Place them shiny side down in the two indicator openings. Use silicone to
hold them in place and avoid handling until the silicone has cured.
4. Connect the interconnect harness to the tachometer and speedometer, also connect the main
harness and the buzzer (optional for audio feedback) to the back of the speedometer, carefully route
the other end of the main harness to the control box mounting location.
636234-B
636243-A
636234-C
636234-B
1977 Style
1968-‘76 Style
6. With the block-off lens secured, place the HDX center gauges over the back of the center bezel
and secure the system by using the four (4) stock mounting screws.
Buzzer Connector

Manual # 650651
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
8. The clusters are now ready to re-install into the vehicle using stock hardware. Refer to
the main manual for wiring instructions to complete the HDX installation.
7. Attach the remaining main harness and the clock harness to the back of the HDX display.
Carefully route the other ends to the control box mounting location and connect the provided Y
harness to the control box so both main harnesses can be connected.
Clock Connector