Dakota Digital VLC-55C User manual

Manual # 650355A
VLC/VLK-55C
Dakota Digital Clock Installation
For 1955-‘56 Chevy Speaker Clocks
VLK Installation
1/8” Clamping
Backplate
2X 6-32 x .875”
Mounting Screws
CAT5 Cable
(Connects Clock to VHX
Control Box)
VLK Clock
Installation Manuals
2. Flip the bezel over. Align the 1/8” thin
Clamping Backplate on the back so the
connector is at the top, then thread the
provided screws into the two locations shown,
clamping the system together.
1. Remove the speaker bezel from the car. Set the
1/4” thick Spacer Subpanel on the back of the
clock, and slide them into the front of the
speaker as shown.
1/4” Spacer
Subpanel
VLC Clock
4X 4-24 x 5/8”
Mounting Screws
Clamping
Backplate
VLK Clock Includes:
VLC Clock includes:
CAT5 Cable
(Connects Clock to VHX
Control Box)
VLC Power Harness

Manual # 650355A
VLC Installation
4510 W. 61st St. N., Sioux Falls SD 57107
Phone: [phone] Fax: [phone]
www.dakotadigital.com
[email protected]
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
4. Connect the CAT5 cable to the clock. Route this
cable back to the control box.
Reinstall the speaker bezel in to the dash and refer to
the Operating Manual to complete the clock setup.
1. Remove the speaker bezel from the car and place the VLC
clock in the speaker bezel from the front. Place the clamping
back plate over the rear of the VLC, and secure the clock
using the four supplied screws.
2. Connect the CAT5 cable and the VLC power
harness to the clock. Route the other ends back
to the control box.
VLK shown mounted