Dancover 3m storage pro User manual

07-10-2019
for
Storage Tent PRO
8x12x5,2m PVC
Manual

Safety Advice
Attention
In some countries approval is needed to set up a tent larger than 75 m2. It is your responsibility
to comply with local rules and regulations and to ensure that the tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the tent is safely secured
and that the tent does not cause damage to others.
Do not use open re, welding equipment or other sources which can ignite, inside or close to the
tent.
The tent must be safely secured. We recommend you secure your tent with straps and pegs as
soon as it is assembled.
Make sure to check if the tent is covered by your home contents insurance.
Tents must be evacuated under extreme weather conditions.
In the event of snow, always remove snow from the roof of the tent regularly to prevent snow
from building on the roof, as heavy snow can cause the tent to collapse.
In the event of rain, there is a risk of rain puddles building up on top of the roof of the tent.
Heavy rain puddles can cause the roof to collapse. It is your responsibility to ensure rain
puddles do not build up. As a precaution, make sure the roof of the tent is stretched out
properly and adequately over the side frames of the tent and remove rain water regularly.
Do not unpack or repack your tent in freezing temperatures. In case of temperatures below
zero, always unpack and repack your tent indoors to avoid the risk of cracking parts.
The tent must be totally dry before you repack and store it to avoid mildew.
Note: Dancover warranty applies only to the normal use of the Product, normal wear and tear
excepted, in accordance with written use instructions or manual. The warranty does not apply
to damage caused by accident, abuse, misuse, or modification of the Product.
Warranty Information
Please visit dancovershop.com for information on warranty.
Please always check our website for the latest safety advice and manual.

Part
number
1
2
4
6
9-1
9-2
10-1
(10-2)
B
11
21
Bo om Leg 1455mm 05ø
Pipe 1880mm 83ø
Pipe 750mm roof
enforcement ver cal
Top Leg 1508mm 05ø
4-way connector roof top
120°, 54-42mm with rings
and flange
4-way connector roof top
120°, 54-42mm with flange
4-way connector roof-leg
120°, 54-42mm with rings
4-way connector roof-leg
120°, 54-42mm
3-way connector flat roof,
54-42mm with flange
4-way connector flat roof,
54-42mm with flange
Footbase 3-way right
connector for corner with 1
ring
31
8x12m Storage Tent
07-10-2019
Descrip on
41
05
7
41
2
3
4
6
4
01
2
Quan
7 Pipe 2188mm 05ø 82
A3-way connector for corner
120°, 54-42mm with rings 4
5Pipe 1980mm roof
enforcement horizontal 41
8
3-way connector for gabel
roof top 120°,54-42mm
with rings and flange
2

2
4
01
2
4
4
4
21
8
21
09
4
02
84
41
15-1
15-2
61
02
12
22
32
42
52
62
72
82
92
Footbase 3-way Le
connector for corner with 1
ring
Footbase 3-way connector
flat for side with rings
Footbase 3-way connector
flat for side
Footbase 2-way connector
flat for gable
Bo om door pillar 05ø
Top door pillar 05ø
Pillar liar
Tension bar for roof revoc
Steelwire buckle set for
side
Steelwire buckle set for
roof
eegnuB
Spiral gep
Large peg mm003x8
Small peg mm081x6
8x12m Storage Tent
07-10-2019

21
42
4
1
30
30
201
801
012
4
4
63
1
2
03
13
23
33
43
53
63
73
83
93
04
14
24
34
Floor tekcarb
Nail 345mm
Rope m5
rennapS
Screw mm03x6M
Wing nut 6M
Screw mm05x8M
Screw mm06x8M
Nut 8M
Tie down tehctar
Rope for pillar rails m01
Steel pilc
fooR
End llaw
8x12m Storage Tent
07-10-2019

5
8
9-2 9-1
5
2
7
B
A
A
4
11 12
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
7
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
12
9-2
10-1
10-1 10-1
9-2 9-1 9-29-1
12
12
12
12
12
12
12
12
12
11
11
A
A
A
A
8
11
11
8
8x12m Storage Tent
Select a flat ground for the tent, unpack the carton and check all the parts including tubes, tent and
accessories... etc. are present as same as list.
Assemble the framework of rooftop by joining the portion (A, 8, 9-1, 9-2, 10-1, B, 11, 12) together with
poles (2.7). To ensure the screw fixed to every pole tightly.
10-1(10-2)B (10-2)B (10-2)B
(10-2)B(10-2)B(10-2)B
10-1
10-1
(10-2)
B(10-2)
B(10-2)
Attach one end of supported pole (4.5) to the joints (8. 11. 9-1. 9-2. 12)

2222
15-2
9-2
9-1
10-1
9-1
9-2
9-2
15-2 15-2
15-1
15-1
15-2
15-2
16
23
to fasten the frame to the ground.
A
B
8x12m Storage Tent
(10-2)

V
Spread the wall panel and door panel attach to framework by using the bangee cords clasping the frame to
grommet that is construct over the wall panel and door panel to ensure stability. Also use the short pegs to fix
the doors to the ground.
Warning
1. In order to avoid the pipes from being rusted by air, the pipes are covered
with oil on the surface. Before you set up the tent, please remove the oil
carefully first to keep the cover clean.
2. Take note that the tent needs to be handled carefully to avoid damage.
3
4
. Do not use force on the frame as the pipes might be damaged in the process.
. Tents are meant as temporary shelter and must be evacuated under
extreme weather conditions.
Please select a suitable site for the tent to avoid the damage to
underground sprinkler systems, water, gas or electrical lines.
8x12m Storage Tent

Contact information
Head office:
Dancover A/S
Nordre Strandvej 119 G
3150 Hellebæk
Denmark
For more information
please visit:
www.dancovershop.com
National contact
Denmark: 70 26 76 20
[e-mail]
UK: 020 8099 7570
[e-mail]
Spain: 911 436 828
[e-mail]
Italy: 02 479 21 198
[e-mail]
Germany: 041 0266 7040
[e-mail]
Switzerland: 0840 000125
[e-mail]
France: 0975 181 800
[e-mail]
Austria: 0662 626935
[e-mail]
Sweden: 040 233 262
[e-mail]
Finland: 0 931 581 720
[e-mail]
Nederland: 0 858 880 524
[e-mail]
Poland: 22 300 8602
[e-mail]
Ireland: 0 151 33 003
[e-mail]
Luxembourg: [phone]
[e-mail]
Portugal: 308 800 899
[e-mail]
Belgium: 0 28 08 08 09
[e-mail]
Norway: 231 00 690
[e-mail]