Danfoss Old ICAD 600 series User manual

24 Volt d.c.
ONLY
Quick Start Guide
ICAD 600/900/1200
Ref. Colour Description
A Black – Common Alarm
B Brown – ICM fully open
C Red – ICM fully closed
D Orange – GND ground
E Yellow + 0/4 - 20 mA Input
F Green + 0/2-10V input or digital
input for on/off control
G Blue + 0/4 - 20 mA Output
I Black + Fail safe supply
Battery / UPS* 19 V d.c.
II White + Supply voltage
24 V d.c.
III Brown –
Digital
Ouput
* Uninterruptable Power Supply
Terminal box -
not supplied
by Danfoss
1 2
3
24 Volt d.c.
ONLY
© Danfoss A/S (AC-SMC/MWA), 05 - 2011 DKRCI.PI.HV0.J2.02 / 520H4887 / 027R9801 1
Before you
start using ICAD:
Tighten CW
Quick Start Guide
Oil

Valve label ID:
4
5
Valve size setup (mandatory)
Programming the ICAD
Changing analogue input signal (optional)
Decrease
value
Edit /
Enter
Increase
value
Hold down for
2 seconds to enter
programming mode.
; 01 ; 10
Press and
go to parameter 10.
Press
Press until
you reach 11 (pass-
word). Press
Press until
you reach parameter 26
Press
11 ; 26
Press or
to select ICM size.
Press
ICM / ICAD is now
calibrating.
0; 26 CA
Hold down for
2 seconds to exit
programming mode.
1: ICM 20 with ICAD 600
2: ICM 25 with ICAD 600
3: ICM 32 with ICAD 600
4: ICM 40 with ICAD 900/1200
5: ICM 50 with ICAD 900/1200
; 01
Hold down for
2 seconds to enter
programming mode.
; 03
Press until you
reach parameter 03.
Press
Press or
to select analogue
input signal.
1: 0-20 mA
2: 4-20 mA*
3: 0-10 V
4: 2-10 V
2; 03
Press
A3
If A3 alarm occurs
the analogue input
signal is out of range.
For further functions,
programming possibilities
and factory settings;
please see ICAD instruction.
24 Volt d.c. ONLY
2 DKRCI.PI.HV0.J2.02 / 520H4887 / 027R9801 © Danfoss A/S (AC-SMC/MWA), 05 - 2011
Note:
If the keypad is not operated within 20 seconds;
time out will automatically exit programming mode.
Hold down for
2 seconds to exit
programming mode.
* default factory setting
; 03
ICM 20 ICM 25-65 ICM 100-150
6: ICM 65 with ICAD 900/1200
7: ICM 100 with ICAD 1200
8: ICM 125 with ICAD 1200
9: ICM 150 with ICAD 1200
When powering up the ICAD, A1 will flash in the display
Factory reset of ICAD
Disconnect power 
Press down and 
simultaneously while
reconnecting power 
Release and 
Note:
If factory reset has been performed the
ICAD will start flashing A1 in the display.