Danfoss VLT AutomationDrive FC 360 User manual

1.1.1 Scope of Delivery
Enclosure Power range [kW] Ordering number
J1 0.37-1.5 132B0275
J1 2.2 132B0276
J2 3.0-5.5 132B0277
J3 7.5 132B0278
J4 11-15 132B0279
J5 18.5-22 132B0280
Table 1.1 Ordering Numbers
1.1.2 Safety Instructions
Voltage [V] Minimum waiting time [minutes]
415
380-480 0.37-7.5 kW 11-22 kW
Table 1.2 Discharge Time
1.1.3 Demounting
Enclosure types J1, J2 and J4
1. Grab the centre handle on the fan and use a flat-
edged screw driver to release the retaining level.
Illustration 1.1 Removing Fan on Enclosure Types J1. J2 and J4
Installation Instructions
VLT® AutomationDrive FC 360 Fan Replacement
MI06F102 - VLT®is a registered Danfoss trademark 1

2. Unplug the fan cable
Illustration 1.2 Fan Cable Plug. Plug Location Depends on Fan
Type
Enclosure type J3
1. Remove the M3x6 screw in the bottom right corner.
Illustration 1.3 Removing Fan Screw on Enclosure Type J3
2. Press the levers on each side of the fan and pull the
fan outwards.
Illustration 1.4 Pulling out Fan on Enclosure Type J3
3. Unplug the fan cable
Illustration 1.5 Fan Cable Plug. Plug Location Depends on Fan
Type
Installation Instructions Fan Replacement
2 MI06F102 - VLT®is a registered Danfoss trademark

Enclosure type J5
1. Remove M4x50 screws in the bottom right and upper
left corners.
Illustration 1.6 Removing Fan Screws on Enclosure Type J5
2. Grab the centre handle an pull the fan outwards.
3. Unplug the fan cable
Illustration 1.7 Fan Cable Plug. Plug Location Depends on Fan
Type
1.1.4 Mounting
1. Connect the fan cable.
2. Mount the fan.
2a Enclosure types J1, J2 and J4: Click the fan
into place.
2b Enclosure types J3 and J5: Mount the fan
and fasten the screws.
Installation Instructions Fan Replacement
MI06F102 - VLT®is a registered Danfoss trademark 3

*MI06F102*
MI06F102132R0210 Rev. 2013-03-21