Daniamant LJ2 User manual
English Version
LJ2 Lifejacket Light
Installation and Maintenance Instructions
Description
LJ2 is a two-piece manually-activated versatile light designed for rapid attachment to lifejackets using a
variety of fixing methods
Daniamant Limited
Unit 3, The Admiral Park, Airport Service Road, Portsmouth, UK PO3 5RQ
Telephone: +44 (0)23 9267 5100 Facsimile: +44 (0)23 9267 5101
www.daniamant.com
51-7005 Issue 10 (C6495)
Installation
Installation methods are shown below. Accessories are supplied to clip into the base of the lamp housing
to assist attachment.
Fixing Plate A flat disc with protrubing tabs, suitable for material up to 3mm thick. Requires two 6mm
holes at 30mm centres.
Hanger Plate Allows the lampholder to be attached to a button.
Crocodile Clip Spring loaded jaws to clip onto webbing, tape or any suitable material.
Maintenance
Routine service and battery replacement
The LJ2 is maintenance free; an annual check is recommended:
1. Check date on battery pack. Battery packs must be replaced not more than 5 years after date of
manufacture. (Standard replacement part 51-A208).
2. Inspect light and batteries for signs of damage or corrosion. Lightly grease battery connector ‘O’
ring with silicone grease and replace connector.Using a suitable pointed tool, depress the test
plunger as shown on Page 4 and check that the light operates. The test plunger is in the centre
of the activator at the top of the battery housing; it is designed to allow testing without breaking
the tamper seal. If the unit is damaged or corrosion is visible the unit is to be replaced.
3. Remove pull tag or toggle from LJ2 battery pack – light should illuminate immediately. If light fails
to operate, replace light and cable assembly with a checked unit. If light operates, replace toggle
in battery pack; test is complete.
After use
Battery pack, light and cable assembly must be changed after use.
Safety
The LJ2 battery contains Lithium. This must be handled correctly:
– Do not incinerate, recharge or dismantle battery pack
– Do not make any external electrical connection
– Store between –30°C and +65°C
Health and Safety information
Daniamant lithium-powered marine safety light systems have a design life of 5 years. The batteries are
hermetically sealed pressurised primary lithium/sulphur dioxide cells, electrically protected by diodes and
fuse and environmentally protected by a moulded plastic housing. In this condition batteries present no
definable hazard to health.
Information on the composition and behaviour of these products is contained in the Product Safety Data
Sheet, available from our website (www.daniamant.com) or on request.
2
In addition to the acces-
sories shown, the lamp-
housing may be sewn in
position and the battery
placed in a pocket.
Testing and switch activation
The pull tag must have
a direct pull and not be
pulled at an angle.
3
Product Disposal Instructions
Daniamant’s Survivor Location Lights contain batteries as well as electrical and
electronic components, and must therefore be segregated from the domestic
waste stream and recycled. Disposing of this product correctly will help save
valuable resources and prevent any potential negative effects on human health
and the environment, which could otherwise arise from inappropriate waste han-
dling. Daniamant’s lights are marked with the symbol below which conveys that
this waste must be treated separately from household waste.
To ensure compliance with the WEEE and Battery Regulations, the Survivor Lo-
cation Lights placed on the market in the UK or Denmark should be returned to
Daniamant in the UK or Denmark, or deposited in your nearest WEEE Designated Collection Facility,
operated by your Local Authority.
Further copies of this installation and maintenance instructions
are available to download from our website www.daniamant.com
A copy of these instructions must be held with the ships/owners training manual.
4
Table of contents
