Datalogic HandScanner MR User manual

HANDSCANNER
QUICKSTART GUIDE
HANDSCANNER
HAND TRIGGER
DATALOGIC CHARGING STATION
HANDSCANNER
DATALOGIC GATEWAY
SCANNER
WEARABLES
S,M,L
Trigger located on the index
nger. Clip left or right.
CONNECTIVITY DEVICE (OPTIONAL) CHARGING STATION

Press the textile trigger. Aim at the barcode and scan.
Use your ngers to press between HandScanner and the
fastening rail of the Hand Trigger. Press the HandScanner up
slightly and push it forward without scratching over the pins.
RELEASE
CONNECT WITH PAIRING BARCODE: 3 OPTIONS
INSERT
SCAN
QUICKSTART GUIDE
ACTIVATE
Insert the HandScanner in the Hand Trigger. Press the textile trigger on the Hand Trigger for about 2
seconds to activate the HandScanner.
Open the app symbol “Insight Mobile” on the mobile
device and scan the Pairing Barcode.
VIA INSIGHT MOBILE
or
01 02
03
04
05
Scan the BLE HID Pairing Barcode.
VIA BLE HID
or
The pins face down. Insert the HandScanner in the
Datalogic Charging Station.
CHARGE
06
HOURS
Scan the Pairing Barcode on the top of the Datalogic
Gateway.
VIA DATALOGIC
GATEWAY

HANDSCANNER IS NOT WORKING
PROBLEM SOLUTION
HandScanner is not reacting /
HandScanner is not scanning
a barcode.
Battery is not charged.
Charge the HandScanner in the Datalogic Charging Station for
at least 20 min.
Hand Trigger is defective.
Change the Hand Trigger.
Battery symbol of the HandScanner
ashes red.
Battery charge is low.
Charge the HandScanner in the Datalogic Charging Station for
at least 20 min.
TROUBLESHOOTING
HANDSCANNER SCANS BADLY
PROBLEM SOLUTION
The crosshairs ( ) /
scan dot ( ) light up, but
the barcodes are hard to scan.
HandScanner glass is dirty.
Clean the HandScanner glass with a cotton swap.
Scanning distance is not optimally used.
Position the HandScanner closer or further away from the
barcode label and scan.
For standard range: 3.9 - 31.5 in (10-80 cm)
For mid range: 11.8 - 59 in (30-150 cm).
The barcode label cannot be read.
Create new barcode label.
NO TRANSMISSION OF BARCODE DATA
PROBLEM SOLUTION
Barcode data is not transferred. HandScanner is not connected to the end device.
1. Scan the Pairing Barcode on the end device /
Datalogic Gateway / in Insight Mobile App.
2. Wait until the HandScanner is connected to the end device and
lights up blue twice briey after a successful connection.
NEED HELP?
datalogic.com/support
Datalogic S.r.l.
Via San Vitalino 13
40012 Lippo
Calderara di Reno BO, Italy
www.datalogic.com
STANDARD SETTINGS:
Barcode Sux: Enter (CR)
DIRECTIVES AND CERTIFICATION:
2014/53/EU Radio Equipment Directive (RED)
2011/65/EU Restriction of Hazardous Substances (RoHS)
PROBLEM COULD NOT BE SOLVED?
Hard Reset:
1. Insert the HandScanner in the Hand Trigger.
2. Hold the trigger pressed for about 15 seconds
3. Release the trigger. Press the trigger again for
about 2 seconds to reactivate the HandScanner.
820118500 Rev. A