Datamax ST-3210 User manual


Connecting the
Printer
Serial Port
!Turn off the printer before
connecting cables
AC Power Connector
Parallel Port
Power On/Off Switch
USB Port
AC Power Connector
Serial Port
Parallel Port
Power On/Off Switch
USB Port

Controlling the
Printer
Indicator Lights:
ONLINE Indicates the printer is ready to accept data.
FAULT Indicates no ticket stock is detected or that a
mechanical malfunction has occurred.
POWER Indicates that main power to the printer is ‘On.’
Buttons:
PAUSE / F1 Allows the operator to temporarily stop printing
(pause mode) or to enter off-line mode.
FEED / F2 Allows the operator to advance the ticket stock to
the next print position.
TEST / F3 Allows the operator to print test tickets when the
printer is in off-line mode.
; Note: More information
on the Front Panel can be
found in Section 3.4 of the
Operator’s Manual.
ST/SV 3210 & ST/SV 3306
Quick Start
Guide
Datamax International
Herbert House
12 Elizabeth Way, Pinnacles
Harlow, Essex CM19 5FE UK
Phone: [phone]
Fax: [phone]
Asia-Pacific
19 Loyang Way
#01-01 CILC Building
Singapore 508724
Phone: [phone]
Fax: [phone]
Corporate Headquarters
4501 Parkway Commerce Blvd.
Orlando, Fl 32808
Phone: [phone]
Fax: [phone]
For the latest products, news, and support visit
our web page at
www.datamaxcorp.com
With USB


Loading
Ticket Stock
¾ST Models only: Unlock the Access
Cover then lift to open (for
convenience, the cover may be
removed by sliding it forward and
then lifting up).
¾Install Ticket Stock and insert it between the Media Guides. ¾Adjust the Media Guides to fit the Ticket Stock, then tighten
the Thumbscrew to secure.
¾Turn ‘On’ the Power Switch.
¾Slide the media through the Media Guides, continue until the
printer grabs the media and automatically completes the
loading process.
; Note: When loading, ensure that the black marks on the
ticket stock face away from you. If the ticket stock does not
feed to the proper position, the Media Sensor may need
adjustment (see Section 4 of the Operator’s Manual for
instructions).

Printing a
Configuration
and Test
Pattern Ticket
¾With the Power Switch turned ‘Off’ and ticket stock loaded, press and hold the FEED Button while turning
the Power Switch ‘On.’ Continue to depress the FEED Button until printing begins.
¾After printing is complete, cycle the Power Switch ‘Off’ and ‘On’ to return the printer to the normal
operating mode.
; Note: The printer maintains a selection of user-modifiable ticket setups, each with a specific print
width, start of print position, and cut/tear position. The default setting for these setups is Stock ID 5 (see
Section 4 of the Operator’s Manual for details).

Additional
Information
Be sure to follow and perform the
suggested cleaning schedule explained
in the Operator’s Manual.
Contacting Datamax…
Corporate Headquarters [phone]
Technical Support [phone]
For the latest products, news, and
support visit our web page at
www.datamaxcorp.com