de smit medical CUBESCAN BioCon-500 User manual

de Smit Medical Systems, Unit 15 Falcons Gate, Dean Road, Yate, Bristol, BS37 5NH
Tel: [phone] || Fax: [phone] || Email: [email protected] || Web: www.desmitmedical.com
v1/10/08/2015/SG - PRODUCTS\MCUBE\BC500\QUICK REFERENCE GUIDE
CUBESCAN BIOCON 500 –QUICK REFERENCE GUIDE
KEY FUNCTIONS
POWER
Press the PWR key (Bottom Left key on the scanner) and the unit will power on, displaying the home
screen on the LCD screen.
After 7 minutes of inactivity (this may vary and can be adjusted in device settings), the system will
automatically turn off.
GENDER SELECT
On the home screen, press the GEN key (Left key) to select patient gender.
On the right side of the LCD, either the male or female icon will be displayed.
Important –For females who have had a hysterectomy, select the male setting.
PROBE PREPARATION
Apply gel.
Position the probe according to the body-shaped picture on the side of the probe. The scan button
should be on patient’s right hand side.
Place the probe above the pubic bone, tilt the probe around 60 degrees pointing at the base of the
spine, and press the probe slightly into the abdomen.
* The location of the bladder might differ according to the individual, the residual urine etc.

de Smit Medical Systems, Unit 15 Falcons Gate, Dean Road, Yate, Bristol, BS37 5NH
Tel: [phone] || Fax: [phone] || Email: [email protected] || Web: www.desmitmedical.com
v1/10/08/2015/SG - PRODUCTS\MCUBE\BC500\QUICK REFERENCE GUIDE
PRE-SCAN
Press the scan key once and the ultrasound image will be displayed on the LCD.
Using the pre-scan image on the LCD, adjust the location and angle of the probe until you find the
largest image of the bladder possible.
Important –Make sure that PRE-SCAN is “On” in device setup. When PRE-SCAN is “Off”, a normal
scan will be done without the PRE-SCAN stage.
SCAN
Press the scan key once more, on either the scanner or the probe.
The scanner will automatically perform a 3D scan of the bladder. Scanning time is around 4 seconds
and the probe should be kept steady.
After scanning has finished, the LCD displays the measurement result.
If the center of the bladder image leans towards a certain area (up, down, left or right), perform
pre-scan again and center the bladder in the image.
To position the bladder in the center of the circle, keep the probe location and adjust the angle of
the probe as shown below.
SCAN RESULT
PRINT AND RESET
Press the Print key and the scanner will print out the readings and images of the highest reading
achieved during the patient’s session.
To diagnose a new patient, press the Reset key and repeat the pre-scan procedure. The Cubescan
will retain the scan data from a patient’s session until the Reset key is pressed.
LCD SCREEN CONTRAST
To adjust the LCD screen contrast, hold down the Enter key and press either the Up key to increase
or Down key to decrease contrast to suit.