McKesson 146-12011KD-2 User manual

BATH SAFETY
Transfer Bench
aluminum frame
Provides a total weight bearing capacity of 400 lbs (181 kg).
INSTRUCTIONS FOR USE
MFR # 146-12011KD-2
OUTSIDE LEGS
32 in x 23 in
(81 cm x 58 cm)
1. Remove contents from carton.
2. Lay transfer bench upside down on a flat surface.
3. Attach leg with the large suction cup (marked “A”)
by depressing the brass push pin and inserting
into the receptacle with the matching “A”. Repeat
for second leg (Figure 1).
ASSEMBLY INSTRUCTIONS
4. Attach leg with small rubber tip (marked “B”) by
depressing brass push pin and inserting into the
receptacle with matching “B”. Repeat for second
leg (Figure 2).
FIGURE 1
FIGURE 2
6. To assemble backrest, insert pole into backrest
support by depressing push pin and sliding into
receptacle. Repeat for second pole (Figure 4).
FIGURE 4
5. Turn transfer bench right-side-up. Attach armrest
by depressing brass push pins and sliding into the
arm receptacle on the side of the bench. Make
sure the arm arcs outward, not inward (Figure 3).
FIGURE 3

7. Insert backrest into base by depressing push pins
and sliding supports through both receptacles.
Note: Backrest must go through both sets of
receptacles to become secure (Figure 5).
FIGURE 5
NOTE: Back support is reversible to accommodate
left or right tub entry. You can also change the seat
depth of your transfer bench by pushing the pins
under the seat and sliding the tubes forward until the
pins lock into place.
8. Place legs with suction cups into bath tub.
1. Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO
NOT USE. Contact dealer/carrier for further
instructions.
2. Make certain that the height adjusting snap
buttons fully protrude through the same
respective hole of each leg extension. This
will ensure that the leg extensions are securely
locked in position and an even height is achieved.
3. Ensure ALL screws, nuts and/or bolts are
tightened.
4. Check the rubber tips on the leg extensions
for rips, wear or if they are missing.
Immediately replace any or all if any of these
imperfections exist.
5. All four leg extensions with rubber tips MUST
touch the floor simultaneously at all times.
6. DO NOT stand on chair.
ADDITIONAL PRECAUTIONS
NOTE: To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water.
Wipe bath seat dry after each use.
1. Before use, adjust height of each leg to your
specific needs, making sure all legs are at the
same height. When desired height is reached,
lock legs into place by aligning buttons into
proper holes.
NOTE: Make sure all legs are set to the same height.
2. To be sure legs are locked into place, push down or
pull up on legs.
ADJUSTING LEG HEIGHT
Technical support, replacement parts and
warranty information? Call 1-866-694-5085
General product questions? Call 1-800-777-4908
Distributed by
McKesson Medical-Surgical Inc.
Richmond, VA 23233
PVN B0518
Made in China
McKesson carries a comprehensive selection of durable
medical equipment products for bath safety, mobility and aids
to daily living, including wheelchairs, canes, bath benches, and
more. Choose McKesson for quality, selection, and value.
For complete details, please visit
mms.mckesson.com/mckesson-brands.