Reison Nordiska 10-458 User manual

10-458 Edit. 1 Page 1( 4)
USERS MANUAL
TRANSPORT HANDLES
10-458
GMDN 35393
PID 122487

10-458 Edit. 1 Page 2( 4)
INTRODUCTION
The transport handle 10-458 is intended to be fixed to the back section of an operating table when
the operating table is to be moved with or without patient. The idea is to avoid moving the table
using the head rest as transport handle. A head rest is not designed to meet the load arising when an
operating table is moved.
The transport handles shall be hooked from the upper side of the accessory rail of the back section
and be locked by tightening the locking handles. At that time a check shall be done that the insides
of the clamps is in contact with the outsides of the accessory rails.
ABOUT USER´S MANUAL
This manual is for clinical personnel, service personnel and others who need knowledge about and
understanding of how the transport handles works and how they can be used.
Read the manual carefully before use of the equipment.
Always follow the directions in the manual.
Always keep the manual close to the equipment.
INSTALLATION
Check at the unpacking, that there are no damages to the equipment. Also check the contents
against the delivery bill and that there are no loose parts in the box.
The packing material consists of cardboard and plastic and can be recycled according to local
directions.
IIMPORTANT SAFETY DIRECTIONS
At the mounting of the transport handles on the back section of the operating table, the responsible
personnel must be sure of that the handles are safety locked to the accessory rail. Any play between
the clamps and the rails is not to be found.
GENERAL DESCRIPTION

10-458 Edit. 1 Page 3( 4)
The transport handles consists of a pair of fixed clamps with universal grooves that fits all accessory
rails on the market. The handles themselves are fixed at the end of an extension rail and are covered
with soft sleeves. The transport handles shall be hooked on the accessory rail from the upper side of
the rail. When the locking handles tightens must be checked that the insides of the clamps are in
contact with the outsides of the rails. The locking handles shall be stiff tightened and any play shall
not be found in the transport handles.
CARE AND MAINTENANCE
Cleaning
Clean with an antiseptic detergent and tempered water. Dry with a soft cloth. Don´t
use detergents containing strong acids or bases. Alcohol may only be used on metal
parts.
Control
Check before every use that the locking systems work properly and that there are no
damages on the handle sleeves where bacteria can grow.
Annual service
Once a year the transport handles shall be carefully cleaned. Threads shall be lubri-
cated with water resistant grease. The sleeves of the handles shall be checked
regarding to damages. If there are any damages or if the sleeves not seems to be in
proper condition they shall be replaced.
SPARE PARTS

10-458 Edit. 1 Page 4( 4)
TECHNICAL SPECIFICATION
Length 40cm
Width 4cm
Height 15cm
Weight (pair) 2,8kg
Box 240 Eriksbergsvägen 32A
734 25 Hallstahammar
Sweden
Phone: [phone] Fax: [phone]
E-mail: [email protected]e
www.reison.se
1. Transport handle left 11889 1pc.
2. Sleeve 11891 2pcs.
3. Transport handle right 11890 1pc.
4. Locking screw M10 10054 2pcs.
5. Plastic plug IKP 16 12-13 2pcs.
6. Locking handle short 10602 2pcs.
7. Set screw MP6SS M5x14 A2 2pcs.